Effect of injection matrix concentration on peak shape and separation efficiency in ion chromatography

Virtual Instruments for Peak-Overlapping Studies to Determine Low- and High-Concentration Components with Ion Chromatography: Potassium and Sodium

We developed the LabVIEW-based virtual instruments (VIs) to bridge a gap in commercial software and to enable systematic peak-overlapping studies to recognise the concentration levels enabling reliable simultaneous determination of major and minor constituents in samples with wide concentration proportions. The VIs were applied to a case study of the ion chromatographic determination of potassium as minor and sodium as a major ion with an IonPac CS12A column and 50 μL injection loop. Two successive studies based on multilevel two-factorial response surface experimental designs, (1) a model peak-overlapping study based on single-ion injections, and (2) an accuracy and precision study, provided guidelines for real sample analyses. By adjusting sample dilutions so that the sodium mass concentration was set to 340 mg/L, the simultaneous determination of potassium in the presence of sodium was possible in samples with sodium over potassium concentration ratios between 14 and 341. The relative expanded uncertainty associated with potassium ion determination was between 0.52 and 4.4%, and the relative bias was between -3.8 and 1.9%. We analysed Ringer's physiologic solutions, standard sea, trisodium citrate anticoagulant, and buffered citrate anticoagulant solutions. We confirmed that the VI-supported peak-overlapping studies contributed to the quality of results by enabling the evidence-based choices of concentration levels adjusted by a dilution.

Matrix effects demystified: Strategies for resolving challenges in analytical separations of complex samples

Matrix effects can significantly impede the accuracy, sensitivity, and reliability of separation techniques presenting a formidable challenge to the analytical process. It is crucial to address matrix effects to achieve accurate and precise measurements in complex matrices. The multifaceted nature of matrix effects which can be influenced by factors such as target analyte, sample preparation protocol, composition, and choice of instrument necessitates a pragmatic approach when analyzing complex matrices. This review aims to highlight common challenges associated with matrix effects throughout the entire analytical process with emphasis on gas chromatography-mass spectrometry, liquid chromatography-mass spectrometry, and sample preparation techniques. These techniques are susceptible to matrix effects that could lead to ion suppression/enhancement or impact the analyte signal at various stages of the analytical workflow. The assessment, quantification, and mitigation of matrix effects are necessary in developing any analytical method. Strategies can be implemented to reduce or eliminate the matrix effect by changing the type of ionization, improving extraction and clean-up methods, optimization of chromatography conditions, and corrective calibration methods. While development of an effective strategy to completely mitigate matrix effects remains elusive, an integrated approach that combines sample preparation, analytical extraction, and effective instrumental analysis remains the most promising avenue for identifying and resolving matrix effects.

Separation and preconcentration of perrhenate from ionic solutions by ion exchange chromatography

Technetium poses an environmental hazard because of its radioactivity and long half-life. It exists in the form of pertechnetate in the environment and can be modeled by the nonradioactive ion perrhenate, since pertechnetate and perrhenate have the same geometry and similar chemical properties. In this research, a new zinc cyclen resorcinarene cavitand (ZCR) column was used in ion chromatography (IC) to efficiently separate perrhenate. Ion chromatography has the advantage of requiring almost no sample preparation for water samples. The ZCR column demonstrated the ability to separate anions: fluoride, chloride, nitrate, sulfate, phosphate, perchlorate, and perrhenate by gradient 2-60 mM NaOH. Unlike other columns, the new column material was selective in retaining perrhenate. The ZCR column also gave a linear range from 2.0 to 1000 mg L^-1 for perrhenate with R² > 0.997. There was a logarithmic relationship between the concentration of perrhenate and its retention time. Excellent perrhenate recovery was achieved on the ZCR column when river water was spiked with perrhenate and perrhenate was preconcentrated. The efficient separations of perrhenate by the ZCR column will potentially assist in pertechnetate separations.

Unbiased Measurement of Phosphate and Phosphorus Speciation in Surface Waters

Trace-level phosphate analysis and phosphorus speciation in surface water remained challenging due to adsorption and phosphate uptake by microorganisms. In this study a two-dimensional ion chromatography separation coupled to electrospray ionization high-resolution mass spectrometry (2D-IC-ESI-MS) allowed isotope dilution quantitation of phosphate with simultaneous analysis of 11 phosphate-containing metabolites and two inorganic condensed phosphates. Samples were collected from Lake St. Clair, Lake Ontario, and Georgian Bay (ON, Canada). Comparative experiments showed lower phosphate results for samples not immediately spiked and for external calibration quantitation. Field spiking with ¹⁸O-labeled phosphate combined with isotope dilution quantitation allows measurement of the phosphate levels existent at the collection time instead of the phosphate concentrations remaining in the samples at the analysis time. This is a significant advantage against the traditional colorimetric and ion chromatographic (IC) analysis methods, which are unable to compensate for the adsorption loss occurring in standards and samples, especially when phosphate is present at levels below 20 μg L^-1 as P (61 μg L^-1 as PO₄^3-). Two phosphate-containing metabolites, adenosine 5'-monophosphate (AMP) and d-glucose 6-phosphate (Glucose-P), were detected in a subset of samples collected from Lake St. Clair, with no statistically significant correlation between them and the simultaneously measured phosphate. Directly bioavailable P (phosphate), indirectly bioavailable P (phosphatase-hydrolyzed P) and nonbioavailable P (nonhydrolizable P) fractions were quantified by measuring phosphate, phosphate after phosphatase addition and total phosphorus. The proposed 2D-IC-ESI-MS method developed for a QExactive MS instrument with field spiking of the internal standard provides accurate phosphate results and eliminates quantitation errors caused by phosphate adsorption. This setup allows simultaneous collection of targeted and nontargeted analysis data and thus the detection of trace polar organic phosphorus metabolites as well.