Alternative solvents for improving the greenness of normal phase liquid chromatography of lipid classes

Applying a Green Solvent with Microwave, Ultrasound, and Soxhlet Extraction Techniques to Quantify the Slip Additive cis-1,3-Docosenamide and Nine Oxidative Degradation Byproducts in Polypropylene Samples

Erucamide is used as an important slip agent for polymers. However, erucamide can degrade during processing and long-term storage, forming various oxidation products. These degradation products can affect the recovery rates of erucamide. In this study, investigated different solid-liquid extraction methods (Soxhlet, microwave, and ultrasound) and used gas chromatography with mass spectrometry (GC-MS) to quantify erucamide and its degradation byproducts in polypropylene (PP). A multivariable experiment was designed, and a mixed-effect approach was used to analyze the results. Various extraction variables were examined, such as temperature, time, solvents, and PP pretreatments. Using a mixed-effect model with a Kenward-Roger approximation, an R2 of the model of 97% and p values of 0.168, 0.000, and 0.000 were obtained for the technical, solvent, and type of PP pretreatment variables, respectively. The highest average recoveries of erucamide were found with the microwave technique and were 96.4% using dichloromethane, 94.57% using cyclohexane, and 93.05% using limonene. With ultrasound, recoveries ranged between 85 and 92% for dichloromethane and limonene. In addition, it was observed that the extraction method had better recovery results in ground PP than in films and in pellets. Nine oxidative degradation byproducts of erucamide were identified and semi-quantified by GC-MS. The reaction mechanisms for forming each byproduct were proposed. The byproducts that experienced a higher rate of degradation of erucamide were erucamide with a hydroxyl group at position one and 12-amino-6-12-oxo-dodecanoic acid, showing more prominent peaks using the Soxhlet method with cyclohexane and dichloromethane as solvents and polypropylene (PP) films as the type of material used.

Reaction of the Phytochemistry Community to Green Chemistry: Insights Obtained Since 1990

This review article aims to study how phytochemists have reacted to green chemistry insights since 1990, the year when the U.S. Environmental Protection Agency launched the "Pollution Prevention Act". For each year in the period 1990 to 2019, three highly cited phytochemistry papers that provided enough information about the experimental procedures utilized were sampled. The "greenness" of these procedures was assessed, particularly for the use of solvents. The highly hazardous diethyl ether, benzene, and carbon tetrachloride did not appear in the papers sampled after 2010. Advances in terms of sustainability were observed mainly in the extraction stage. Similar progress was not observed in purification procedures, where chloroform, dichloromethane, and hexane regularly have been employed. Since replacing such solvents in purification procedures should be a major goal, potential alternative approaches are discussed. Moreover, some current initiatives toward a more sustainable phytochemical research considering aspects other than only solvents are highlighted. Although some advances have been achieved, it is believed that natural products chemists can play a major role in developing a novel ecological paradigm in chemistry. To contribute to this objective, six principles for performing natural products chemistry consistent with the guidelines of green chemistry are proposed.

Green extraction of oil from Carum carvi seeds using bio-based solvent and supercritical fluid: Evaluation of its antioxidant and anti-inflammatory activities

INTRODUCTION

The consumption of health-promoting products such as oil seeds may improve human health and prevent certain diseases. Carvi seeds have the potential to produce oil with nutritional and functional properties rich in active compounds.

OBJECTIVE

To extract bioactive lipids from Carum carvi seeds using green methodologies.

MATERIAL AND METHODS

Supercritical-carbon dioxide (Sc-CO₂ ) and ethanol as co-solvent and bio-based solvent 2-methyltetrahydrofuran (MeTHF) were used to extract the oil from Carum carvi. The yield, the chemical composition, as well as antioxidant and anti-inflammatory activities of green extracted oils were investigated and compared to those obtained with conventional methods (hexane and Folch system).

RESULTS

MeTHF extraction gave higher oil yield than that obtained by hexane. Fatty acids composition of the two obtained green extracted oils was similar to conventional extracted ones where petroselinic (39-43%), linoleic (29-31%) and oleic (19-21%) acids were the major compounds. Furthermore, MeTHF and Sc-CO₂ green extracted oils were enriched of bioactive compounds including sterols (5.4 and 7.3 mg/g oil) and total polyphenols (9.3 and 7.6 mg GAE/g oil) which were correlated to enhanced antiradical capacity. Moreover, the green extracted oils exhibited high anti-inflammatory capacity inhibiting nitric oxide (NO) release in lipopolysaccharide (LPS)-induced RAW 264.7 macrophages with IC₅₀ values of 28 and 24 μg/mL.

CONCLUSION

Green solvents are a good alternative to petroleum solvents to recover oil from carvi seeds with high amount of nutritionally important fatty acids, along with significant antioxidant and anti-inflammatory potential.

Cyclopentyl Methyl Ether (CPME): A Versatile Eco-Friendly Solvent for Applications in Biotechnology and Biorefineries

The quest for sustainable solvents is currently a matter of intense research and development, as solvents significantly contribute heavily to the waste generated by chemical industries. Cyclopentyl methyl ether (CPME) is a promising eco-friendly solvent with valuable properties such as low peroxide formation rate, stability under basic and acidic conditions, and relatively high boiling point. This Review discusses the potential use of CPME for applications in biotechnology (e.g., biotransformations, as solvent or cosolvent), biorefineries, and bioeconomy (e.g., for furan synthesis or as an extractive agent in liquid-liquid separations), as well as for other purposes, such as chromatography or peptide synthesis. Although CPME is currently produced by petrochemical means with a remarkably high atom economy, its biogenic production can be envisaged from substrates such as cyclopentanol or cyclopentanone, which can be derived from furfural or from (bio-based) adipic acid, respectively. The combination of the promising properties of CPME as a (co)solvent with a future (economic) biogenic origin would be advantageous for setting strategies aligned with the sustainable chemistry principles.

Cyclopentyl Methyl Ether: An Elective Ecofriendly Ethereal Solvent in Classical and Modern Organic Chemistry

Solvents represent one of the major contributions to the environmental impact of fine-chemical synthesis. As a result, the use of environmentally friendly solvents in widely employed reactions is a challenge of vast real interest in contemporary organic chemistry. Within this Review, a great variety of examples showing how cyclopentyl methyl ether has been established as particularly useful for this purpose are reported. Indeed, its low toxicity, high boiling point, low melting point, hydrophobicity, chemical stability towards a wide range of conditions, exceptional stability towards the abstraction of hydrogen atoms, relatively low latent heat of vaporization, and the ease with which it can be recovered and recycled enable its successful employment as a solvent in a wide range of synthetic applications, including organometallic chemistry, catalysis, biphasic reactions, oxidations, and radical reactions.