Denitrification performance and characteristics of untreated corncob for enhanced nitrogen removal of municipal sewage with low C/N ratio

Nitrogen removal efficiency and mechanisms of an improved anaerobic-anoxic-oxic system for decentralized sewage treatment

The unstable operation and poor effluent quality often associated with decentralized sewage treatment systems due to fluctuating water flows have garnered significant attention. In this study, a novel integrated process combining anoxic denitrification and simultaneous nitrification and denitrification was developed to address these challenges. The improved anaerobic-anoxic-aerobic system achieved average effluent concentrations of 20.83 mg/L and 4.63 mg/L for chemical oxygen demand and NH4+-N, with average removal rates of 91 % and 68 %, respectively. Moreover, the aerobic zone demonstrated an impressive efficiency of 40.8 % for simultaneous nitrification and denitrification. The key bacteria groups driving the system's performance were heterotrophic and aerobic nitrifying bacteria, which dominated the microbial populations. Overall, the system optimizes the traditional anaerobic-anoxic-aerobic process, providing an effective solution for fluctuating wastewater flows. It establishes a successful coexistence model for multiple microbial populations, highlighting its applicability for superior nitrogen removal performance, and reference for optimizing rural sewage treatment. TAKE HOME MESSAGE SENTENCE: The improved anaerobic-anoxic-aerobic system for fluctuating wastewater treatment has superior nitrogen removal performance depending on multiple microbial populations.

Effect of microbial communities on nitrogen and phosphorus metabolism in rivers with different heavy metal pollution

Small urban and rural rivers usually face heavy metal pollution as a result of urbanization and industrial and agricultural activities. To elucidate the metabolic capacity of microbial communities on nitrogen and phosphorus cycle in river sediments under different heavy metal pollution backgrounds, this study collected samples in situ from two typical rivers, Tiquan River and Mianyuan River, with different heavy metal pollution levels. The microbial community structure and metabolic capacity of nitrogen and phosphorus cycles of sediment microorganisms were analyzed by high-throughput sequencing. The results showed that the major heavy metals in the sediments of the Tiquan River were Zn, Cu, Pb, and Cd with the contents of 103.80, 30.65, 25.95, and 0.44 mg/kg, respectively, while the major heavy metals in the sediments of the Mianyuan River were Cd and Cu with the contents of 0.60 and 27.81 mg/kg, respectively. The dominant bacteria Steroidobacter, Marmoricola, and Bacillus in the sediments of the Tiquan River had positive correlations with Cu, Zn, and Pb while are negatively correlated with Cd. Cd had a positive correlation with Rubrivivax, and Cu had a positive correlation with Gaiella in the sediments of the Mianyuan River. The dominant bacteria in the sediments of the Tiquan River showed strong phosphorus metabolic ability, and the dominant bacteria in the sediments of the Mianyuan River showed strong nitrogen metabolic ability, corresponding to the lower total phosphorus content in the Tiquan River and the higher total nitrogen content in the Mianyuan River. The results of this study showed that resistant bacteria became dominant bacteria due to the stress of heavy metals, and these bacteria showed strong nitrogen and phosphorus metabolic ability. It can provide theoretical support for the pollution prevention and control of small urban and rural rivers and have positive significance for maintaining the healthy development of rivers.

Sodium hydroxide or tetramethylammonium hydroxide modified corncob combined with biodegradable polymers to prepare slow-release carbon source for wastewater denitrification

This study proposed a method to improve the bioavailability of artificially prepared carbon sources for the purpose of wastewater denitrification. This carbon source (named SPC) was prepared by mixing corncobs with poly(3-hydroxybutyrate-3-hydroxyvalerate) (PHBV), where the corncobs were pretreated by NaOH or TMAOH. The results of compositional analysis and FTIR showed that both NaOH and TMAOH degraded lignin, hemicellulose and their connection bonds in corncob, thus increased the cellulose content from 39% to 53% and 55%, respectively. The cumulative carbon release from SPC was about 9.3 mg/g and was consistent with both the first-order kinetic and Ritger-Peppas equation. The released organic matters contained low concentration of refractory components. Correspondingly, it showed excellent denitrification performance in simulated wastewater, and the total nitrogen (TN) removal rate was above 95% (influent NO₃^--N was 40 mg/L) and effluent residual chemical oxygen demand (COD) was less than 50 mg/L.

Transmission and retention of antibiotic resistance genes (ARGs) in chicken and sheep manure composting

Transmission of ARGs during composting with different feedstocks (i.e., sheep manure (SM), chicken manure (CM) and mixed manure (MM, SM:CM= 3:1 ratio) was studied by metagenomic sequencing. 53 subtypes of ARGs for 22 types of antibiotics were identified as commonly present in these compost mixes; among them, CM had higher abundance of ARGs, 1.69 times than that in SM, while the whole elimination rate of CM, MM and SM were 55.2%, 54.7% and 42.9%, respectively. More than 50 subtypes of ARGs (with 8.6%, 11.4% and 20.9% abundance in the initial stage in CM, MM and SM composting) were "diehard" ARGs, and their abundance grew significantly to 56.5%, 63.2% and 69.9% at the mature stage. These "diehard" ARGs were transferred from initial hosts of pathogenic and/or probiotic bacteria to final hosts of thermophilic bacteria, by horizontal gene transfer (HGT) via mobile gene elements (MGEs), and became rooted in composting products.

Enhanced nitrogen removal from low C/N municipal wastewater employing algal biochar supported nano zero-valent iron (ABC-nZVI) using A/A/O-MBR: Duration and rehabilitation

To bridge the organic-dependent barrier on nitrogen from low carbon/nitrogen (C/N) municipal wastewater, employing algal biochar supported nano zero-valent iron (ABC-nZVI) was investigated using A/A/O-MBR. Firstly, it can be seen that adequate carbon source is indispensable for the removal, since total nitrogen (TN) removal reached 77.89 % with the influent C/N of 7.8. Secondly, conducted in batch experiments with different doses of ABC-nZVI with/without active sludge, removal efficiency of total inorganic nitrogen (TIN) and the effective time achieved 84.94 % and 24 h with an ABC-nZVI dose of 300 mg/L, respectively. Thirdly, it was found that the duration of high-efficiency denitrification reached 9 h with the addition of 250 mg/L of ABC-nZVI to the anoxic tank of A/A/O-MBR, and the effluent ammonium nitrogen (NH₄⁺-N) also meet the national discharge standard. Besides, biodiversity of both anoxic and aerobic sludge was apparently promoted with the addition of ABC-nZVI, while the lab-scale A/A/O-MBR could also be fully rehabilitated within 12 h. Finally, predicted through PICRUSt2, relevant abundance of functional genes involved in nitrogen metabolism could be enriched by nZVI addition. As an alternative supporting electron donor and mediator, ABC-nZVI can also be participated in the enhanced nitrogen removal in A/A/O-MBR at low C/N.

The research progress, hotspots, challenges and outlooks of solid-phase denitrification process

Nitrogen pollution is one of the main reasons for water eutrophication. The difficulty of nitrogen removal in low-carbon wastewater poses a huge potential threat to the ecological environment and human health. As a clean biological nitrogen removal process, solid-phase denitrification (SPD) was proposed for long-term operation of low-carbon wastewater. In this paper, the progress, hotspots, and challenges of the SPD process based on different solid carbon sources (SCSs) are reviewed. Compared with synthetic SCS and natural SCS, blended SCSs have more application potential and have achieved pilot-scale application. Differences in SCSs will lead to changes in the enrichment of hydrolytic microorganisms and hydrolytic genes, which indirectly affect denitrification performance. Moreover, the denitrification performance of the SPD process is also affected by the physical and chemical properties of SCSs, pH of wastewater, hydraulic retention time, filling ratio, and temperature. In addition, the strengthening of the SPD process is an inevitable trend. The strengthening measures including SCSs modification and coupled electrochemical technology are regarded as the current research hotspots. It is worth noting that the outbreak of the COVID-19 epidemic has led to the increase of disinfection by-products and antibiotics in wastewater, which makes the SPD process face challenges. Finally, this review proposes prospects to provide a theoretical basis for promoting the efficient application of the SPD process and coping with the challenge of the COVID-19 epidemic.

Solid slow-release carbon sources improve the simultaneous nitrification and denitrification processes in low carbon resource wastewater

In this study, A Acinetobacter pittii sp. was isolated with high efficiency for heterotrophic nitrification and aerobic denitrification (HN-AD). The boundary conditions for total nitrogen (TN) removal were as follows: C/N ratios 8-14, temperature 25-35 °C, initial pH 7-9, and shaker speed 100-120 rpm. Addition of mixed carbon resources achieved 97.38 % ammonia-N and 91.50 % TN removal, which was higher than that of the group with sole carbon resources. The ammonia-N and TN removal profiles matched well with first-order kinetics in the rapid response period and zero-order kinetics in the slow reaction period. Meanwhile, enzyme activity related to nitrogen conversion would remarkably increase with mixed carbon resources. Furthermore, proposed a possible relationship between the solid carbon source, hydrolysis, soluble small molecule organic matter, microbial activity, and heterotrophic nitrification and aerobic denitrification (HN-AD). This study provides a new strategy for improving nitrogen removal in wastewater with low-carbon resources.

Agriculture Waste as Slow Carbon Releasing Source of Mixotrophic Denitrification Process for Treating Low C/N Wastewater

Mixotrophic denitrification has showed great potential for treating wastewater with a low C/N ratio. Mixotrophic denitrification is the process combining autotrophic denitrification and heterotrophic denitrification in one system. It can compensate the disadvantage of the both denitrifications. Instead of using sodium acetate and glucose as carbon source for the heterotrophic denitrification, agriculture solid wastes including rice straw (RS), wheat straw (WS), and corncob (CC) were employed in this study to investigate their potential as carbon source for treating low C/N wastewater. The carbon releasing pattern of the three carbon rich materials has been studied as well as their capacity in denitrification. The results showed that the highest denitrification occurred in the corncob system which was 0.34 kg N/(m3·d). Corncob was then selected to combine with sulfur beads to build the mixotrophic denitrification system. The reactor packed with sulfur bead on the top and corncob on the bottom achieved 0.34 kg N/(m3·d) denitrification efficiency, which is higher than that of the reactor packed with completely mixed sulfur bead and corncob. The autotrophic denitrification and heterotrophic denitrification were 42.2% and 57.8%, respectively. The microorganisms in the sulfur layer were Thermomonas, Ferritrophicum, Thiobacillus belonging to autotrophic denitrification bacteria. Kouleothrix and Geothrix were mostly found in the corncob layer, which have the function for fiber hydrolysis and denitrification. The study has provided an insight into agriculture solid waste application and enhancement on denitrification of wastewater treatment.