Ozone-enhanced TiO2 nanotube arrays for the removal of COVID-19 aided antibiotic ciprofloxacin from water: Process implications and toxicological evaluation

Enhancing catalytic activity of CuCoFe-layered double oxide towards peroxymonosulfate activation by coupling with biochar derived from durian peel for antibiotic degradation: The role of C=O in biochar and underlying mechanism of built-in electric field

CuCoFe-LDO/BCD was successfully synthesized from CuCoFe-LDH and biochar derived from durian shell (BCD). Ciprofloxacin (CFX) degraded more than 95% mainly by O2•- and 1O2 in CuCoFe-LDO/BCD(2/1)/PMS system within 10 min with a rate constant of 0.255 min-1, which was 14.35 and 2.66 times higher than those in BCD/PMS and CuCoFe-LDO/PMS systems, respectively. The catalytic system exhibited good performance over a wide pH range (3-9) and high degradation efficiency of other antibiotics. Built-in electric field (BIEF) driven by large difference in the work function/Fermi level ratio between CuCoFe-LDO and BCD accelerated continuous electron transfer from CuCoFe-LDO to BCD to result in two different microenvironments with opposite charges at the interface, which enhanced PMS adsorption and activation via different directions. As a non-radical, 1O2 was mainly generated via PMS activation by C=O in BCD. The presence of C=O in BCD resulted in an increase in atomic charge of C in C=O and redistributed the charge density of other C atoms. As a result, strong adsorption of PMS at C atom in C=O and other C with a high positive charge was favorable for 1O2 generation, whereas an enhanced adsorption of PMS at negatively charged C accounted for the generation of •OH and SO4•-. After adsorption, electrons in C of BCD became deficient and were fulfilled with those transferred from CuCoFe-LDO driven by BIEF, which ensured the high catalytic activity of CuCoFe-LDO/BCD. O2•-, on the other hand, was generated via several pathways that involved in the transformation of •OH and SO4•- originated from PMS activation by the transition of metal species in CuCoFe-LDO and negatively charged C in BCD. This study proposed a new idea of fabricating a low-cost metal-LDH and biomass-derived catalyst with a strong synergistic effect induced by BIEF for enhancing PMS activation and antibiotic degradation.

Phyto-fabricated ZnO nanoparticles for anticancer, photo-antimicrobial effect on carbapenem-resistant/sensitive Pseudomonas aeruginosa and removal of tetracycline

Alternanthera sessilis (AS) leaf extract was used to synthesize zinc oxide nanoparticles (ZnO NPs). Bioanalytical characterization techniques such as X-ray diffraction (XRD) and field emission scanning electron microscope (FESEM) confirmed the formation of crystalline ZnO NPs with average sizes of 40 nm. The AS-ZnO NPs antimicrobial activity was analyzed under dark (D) and white light (WL) conditions. The improved antimicrobial activity was observed against Escherichia coli, Staphylococcus aureus and Bacillus subtilis at the minimal inhibitory concentration (MIC) of 125 and 62.5 µg/mL under WL than the D at 125 and 250 µg/mL for E. coli, B. subtilis, and Pseudomonas aeruginosa, respectively. In contrast, the growth of P. aeruginosa and S. aureus was not completely inhibited until 1 mg/mL AS-ZnO NPs under WL and D. Similarly, AS-ZnO NPs displayed a weaker inhibitory effect against carbapenem-sensitive P. aeruginosa (CSPA) and carbapenem-resistant P. aeruginosa (CRPA) strains of PAC023, PAC041 and PAC032, PAC045 under D. Interestingly, the distinct inhibitory effect was recorded against CSPA PAC041 and CRPA PAC032 in which the bacteria growth was inhibited 99.9% at 250, 500 µg/mL under WL. The cytotoxicity results suggested AS-ZnO NPs demonstrated higher toxicity to MCF-7 breast cancer cells than the RAW264.7 macrophage cells. Further, AS-ZnO NPs exhibited higher catalytic potential against tetracycline hydrochloride (TC-H) degradation at 65.6% and 60.8% under WL than the dark at 59.35% and 48.6% within 120 min. Therefore, AS-ZnO NPs can be used to design a photo-improved antimicrobial formulation and environmental catalyst for removing TC-H from wastewater.

Synthesis of TiO2 nanotubes from ilmenite with CuS nanoparticles as efficient visible-light photocatalyst

Titanium dioxide nanotube (TNT) is one of the most widely used photocatalysts. In this research, TNT was prepared by a facile method using ilmenite (FeTiO3) concentrate as the titanium source. For this purpose, iron was leached out from ilmenite using HCl in assistance with the iron powder as the reducing agent to produce pure TiO2, where consequently, TNT was produced through hydrothermal treatment of the prepared TiO2 in an alkaline solution. CuS quantum dots, using the L-cysteine as a linker, were coated on the TNT to improve TNTs' photocatalytic properties. Characterization was done using XRD, SEM, FESEM, HRTEM, FT-IR, nitrogen sorption, and band gap measurement. The results revealed the formation of TNT with a star-shaped macrostructure as well as, a good dispersion of uniform CuS quantum dots with an average diameter of a few nanometers on the TiO2 structure. A dye adsorption kinetics study of the TNT and CuS-dopped TNT showed that TNT carries a higher adsorption capacity compared to the CuS-dopped TNT, developed due to its higher surface area and pore volume. Next, the photocatalytic performance (under visible light) of the prepared composite was studied over the methylene blue (MB) and malachite green (MG) dyes, after the determination of the dye adsorption equilibrium point (where the adsorption stops). TNT showed almost no dye degradation while the prepared composite degraded almost 95 % of the dyes as the result of the reduced band gap from 3.21 to 2.67 eV. In this study, for the first time, the TNT was prepared using a mineral source and ilmenite, enhanced in photocatalytic properties, and presented a successful application.

Nanomaterials Aspects for Photocatalysis as Potential for the Inactivation of COVID-19 Virus

Coronavirus disease-2019 is caused by severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) and is the most difficult recent global outbreak. Semiconducting materials can be used as effective photocatalysts in photoactive technology by generating various reactive oxidative species (ROS), including superoxide (•O2−) and hydroxyl (•OH) radicals, either by degradation of proteins, DNA, and RNA or by inhibition of cell development through terminating the cellular membrane. This review emphasizes the capability of photocatalysis as a reliable, economical, and fast-preferred method with high chemical and thermal stability for the deactivation and degradation of SARS-CoV-2. The light-generated holes present in the valence band (VB) have strong oxidizing properties, which result in the oxidation of surface proteins and their inactivation under light illumination. In addition, this review discusses the most recent photocatalytic systems, including metals, metal oxides, carbonaceous nanomaterials, and 2-dimensional advanced structures, for efficient SARS-CoV-2 inactivation using different photocatalytic experimental parameters. Finally, this review article summarizes the limitations of these photocatalytic approaches and provides recommendations for preserving the antiviral properties of photocatalysts, large-scale treatment, green sustainable treatment, and reducing the overall expenditure for applications.

Degradation of levofloxacin in wastewater by photoelectric and ultrasonic synergy with TiO2/g-C3N4@AC combined electrode

A novel particle combined electrode named TiO₂/g-C₃N₄@AC (TGCN-AC) was prepared by loading TiO₂ and g-C₃N₄ on activated carbon through gel method, which was used to degrade levofloxacin (LEF) in pharmaceutical wastewater by photoelectric process. The remarkable physicochemical features of particle electrodes were verified by using diverse characterization techniques including SEM-EDS, XRD, FT-IR, BET and pH_ZPC. EIS-CV and photocurrent showed excellent electrocatalysis and photoelectrocatalysis performance of particle electrodes. The photocatalytic characteristics and fluorescence properties of the particle electrode were proved by UV-vis DRS and PL spectra measurements. Combined with Tauc's plot and Mott-Schottky plots curves, the E_CB and E_VB of particle electrodes were determined. The experiments on different influence factors such as pH, ultrasonic, aeration, current density and the concentration of LEF were carried out in the photoelectric reactor. Under the conditions of pH values 3.0, 200 W ultrasonic, 8 L/min aeration, the mass ratio of g-C₃N₄ and TiO₂ is 8%, after 4.0 h of photoelectric process, about 94.76% of LEF (20 mg/L) in water was degraded. TGCN-AC also has excellent reusability. The degradation rate of LEF can still reach 71.17% after repeated use for 6 times. Scavenger studies showed that h⁺ and O^2- were the main active species. By observing the colony size of E. coli, it was proved that the LEF in the effluent had no antibacterial activity. The degradation pathways of LEF was analyzed and drawn by HPLC-MS spectra.