A new perspective on mechanical characterisation of Arabidopsis stems through vibration tests

Lodging resistance of rice plants studied from the perspective of culm mechanical properties, carbon framework, free volume, and chemical composition

In this study, four varieties of rice were cultivated on the same farmland under same conditions and for same duration. However, their lodging resistance was found to be obviously different from each other. Herein, three key factors that highly influenced the lodging resistance were identified. First, in terms of morphological trait, in contrast to the generally believed theory that the overall thickness of the fresh culm wall governs the strength, the thickness of the depressed region of the dried basal culm wall largely determined the mechanical properties by acting as the weak link. This depressed region represents the vulnerable part with high syneresis rate. Second, the culm and its carbon framework exhibited sufficient strength and rigidity for both support and stability of the rice stem. The constraint of high lodging resistance of rice plants is attributed to the culm flexibility. Furthermore, the results of the positron annihilation lifetime spectroscopy corroborate that the most amorphous part and the highest-fraction free volume in the culm carbon framework were found for samples that exhibited high lodging resistance. This result confirmed the significant influence of the culm flexibility on lodging resistance. Third, a higher level of nitrogen element content in the basal culm can benefit its growth and development, which may contribute to an increase in lodging resistance of rice plants.

Unidirectional versus bidirectional brushing: Simulating wind influence on Arabidopsis thaliana

Plants acclimate to various types of mechanical stresses through thigmomorphogenesis and alterations in their mechanical properties. Although resemblance between wind- and touch-induced responses provides the foundation for studies where wind influence was mimicked by mechanical perturbations, factorial experiments revealed that it is not always straightforward to extrapolate results induced by one type of perturbation to the other. To investigate whether wind-induced changes in morphological and biomechanical traits can be reproduced, we subjected Arabidopsis thaliana to two vectorial brushing treatments. Both treatments significantly affected the length, mechanical properties and anatomical tissue composition of the primary inflorescence stem. While some of the morphological changes were found to be in line with those induced by wind, changes in the mechanical properties exhibited opposite trends irrespective of the brushing direction. Overall, a careful design of the brushing treatment gives the possibility to obtain a closer match to wind-induced changes, including a positive tropic response.

Wind-evoked anemotropism affects the morphology and mechanical properties of Arabidopsis

Plants are known to exhibit a thigmomorphogenetic response to mechanical stimuli by altering their morphology and mechanical properties. Wind is widely perceived as mechanical stress and in many experiments its influence is simulated by applying mechanical perturbations. However, it is known that wind-induced effects on plants can differ and at times occur even in the opposite direction compared with those induced by mechanical perturbations. In the present study, the long-term response of Arabidopsis thaliana to a constant unidirectional wind was investigated. We found that exposure to wind resulted in a positive anemotropic response and in significant alterations to Arabidopsis morphology, mechanical properties, and anatomical tissue organization that were associated with the plant's strategy of acclimation to a windy environment. Overall, the observed response of Arabidopsis to wind differs significantly from previously reported responses of Arabidopsis to mechanical perturbations. The presented results suggest that the response of Arabidopsis is sensitive to the type of mechanical stimulus applied, and that it is not always straightforward to simulate one type of perturbation by another.