Observation of 1H-13C and 1H-1H proximities in a paramagnetic solid by NMR at high magnetic field under ultra-fast MAS

A combined solid-state 1H, 13C, 17O NMR and periodic DFT study of hyperfine coupling tensors in paramagnetic copper(II) compounds

We report solid-state 1H, 13C, and 17O NMR determination of hyperfine coupling tensors (A-tensors) in several paramagnetic Cu(II) (d9, S = 1/2) complexes: trans-Cu(DL-Ala)2·H217O, Cu([1-13C]acetate)2·H2O, Cu([2-13C]acetate)2·H2O, and Cu(acetate)2·H217O. Using these new experimental results and some A-tensor data available in the literature for trans-Cu(L-Ala)2 and K2CuCl4·2H2O, we were able to examine the accuracy of A-tensor computation from a periodic DFT method implemented in the BAND program. We evaluated A-tensors on 1H (I = 1/2), 13C (I = 1/2), 14N (I = 1), 17O (I = 5/2), 39K (I = 3/2), 35Cl (I = 3/2), and 63Cu (I = 3/2) nuclei over a range spanning more than 3 orders of magnitude. We found that the BAND code can reproduce reasonably well the experimental results for both A-tensors and nuclear quadrupole coupling tensors.

Proton-detected fast-magic-angle spinning NMR of paramagnetic inorganic solids

Fast (60 kHz) magic angle spinning solid-state NMR allows very sensitive proton detection in highly paramagnetic organometallic powders. We showcase this technique with the complete assignment of ¹H and ¹³C resonances in a high-spin Fe(ii) polymerisation catalyst with less than 2 mg of sample at natural abundance.

Forcing the 'lazy' protons to work

The combination of cross-polarization (CP) with flip-back (FB) pulse has enabled in NMR the enhancement of 13C sensitivity and the decrease of the recycling delay at both moderate and fast magic-angle spinning (MAS) frequencies. However, only continuous-wave (CW) decoupling is presently compatible with FB-pulse (FB-CW), and depending on the CW radio-frequency (rf) field, either an insignificant sensitivity gain or an acquisition time-dependent gain and a low 13C resolution are obtained. In this study, we propose a new FB-pulse method in which radio frequency-driven recoupling (RFDR) is used as the 1H-13C decoupling scheme to overcome these drawbacks. The performances of FB-RFDR in terms of decoupling efficiency and sensitivity gain are tested on both natural abundance (NA) and uniformly 13C-15N labeled l-histidine·HCl·H2O (Hist) samples at a MAS frequency of νR = 70 kHz. The results show the superiority of RFDR over the CW decoupling with respect to these criteria. Importantly, they reveal that the sensitivity gain offered by FB-RFDR is nearly independent of the decoupling/acquisition duration. The application of FB-RFDR on NA-Hist and sucrose yields a sensitivity gain between 60 and 100% compared to conventional FB-CW and CPMAS-SPINAL experiments. Moreover, we compare the 13C sensitivities of NA-Hist obtained by our 1D FB-RFDR method and 2D 1H-{13C} double-CP acquisition. Both methods provide similar 13C sensitivity and are complementary. Indeed, the 2D method has the advantage of also providing the 1H-13C spatial proximities, but its sensitivity for quaternary carbons is limited; whereas our 1D FB-RFDR method is more independent of the type of carbon, and can provide a 13C 1D spectrum in a shorter experimental time. We also test the feasibility of FB-RFDR at a moderate frequency of νR = 20 kHz, but the experimental results demonstrate a poor resolution as well as a negligible sensitivity gain.

Minimizing the t1-noise when using an indirect 1H high-resolution detection of unlabeled samples

The most utilized through-space correlation ¹H-{X} methods with proton indirect detection use two consecutive transfers, ¹H → X and then X → ¹H, with the evolution time t₁ in the middle. When the X isotope is not 100% naturally abundant (NA), only the signal of the protons close to these isotopes is modulated by the ¹H-X dipolar interactions. This signal is theoretically disentangled with phase-cycling from the un-modulated one. However, this separation is never perfect and it may lead to t₁-noise in case of isotopes with very small NA, such as ¹³C or even worse ¹⁵N. One way to reduce this t₁-noise is to minimize, 'purge', during t₁ the un-modulated ¹H magnetization before trying to suppress it with phase-cycling. We analyze experimentally several sequences following the HORROR condition, which allow purging the ¹H transverse magnetization. The comparison is made at three spinning speeds, including very fast ones for ¹H resolution: 27.75, 55.5 and 111 kHz. We show (i) that the efficiency of this purging process increases with the spinning speed, and (ii) that the best recoupling sequences are the two simplest ones: XY and S₁ = SR2¹₂. We then compare the S/N that can be achieved with the two most used ¹H-{X} 2D methods, called D-HMQC and CP-CP. The only difference in between these two methods is that the transfers are done with either two π/2-pulses on X channel (D-HMQC), or two Cross-Polarization (CP) transfers (CP-CP). The first method, D-HMQC, is very robust and should be preferred when indirectly detecting nuclei with high NA. The second method, CP-CP, (i) requires experimental precautions to limit the t₁-noise, and (ii) is difficult to use with quadrupolar nuclei because the two CP transfers are then not efficient nor robust. However, CP-CP is presently the best method to indirectly detect isotopes with small NA, such as ¹³C and ¹⁵N.

Ultra fast magic angle spinning solid - state NMR spectroscopy of intact bone

Ultra fast magic angle spinning (MAS) has been a potent method to significantly average out homogeneous/inhomogeneous line broadening in solid-state nuclear magnetic resonance (ssNMR) spectroscopy. It has given a new direction to ssNMR spectroscopy with its different applications. We present here the first and foremost application of ultra fast MAS (~60 kHz) for ssNMR spectroscopy of intact bone. This methodology helps to comprehend and elucidate the organic content in the intact bone matrix with resolution and sensitivity enhancement. At this MAS speed, amino protons from organic part of intact bone start to appear in (1) H NMR spectra. The experimental protocol of ultra-high speed MAS for intact bone has been entailed with an additional insight achieved at 60 kHz.