Hydrogen fluoride concentrations in ambient air of an urban area based on the emissions of a major phosphogypsum deposit (SW, Europe)

Environmental assessment of phosphogypsum: A comprehensive geochemical modeling and leaching behavior study

Understanding the variations in the geochemical composition of phosphogypsum (PG) destined for storage or valorization is crucial for assessing the safety and operational efficacy of waste management. The present study aimed to investigate the environmental behavior of PG using different leaching tests and to evaluate its geochemical behavior using geochemical modeling. Regarding the chemical characterization, the PG samples were predominantly composed of Ca (23.03-23.35 wt%), S (17.65-17.71 wt%), and Si (0.75-0.82 wt%). Mineralogically, the PG samples were primarily composed of gypsum (94.2-95.9 wt%) and quartz (1.67-1.76 wt%). Moreover, the automated mineralogy revealed the presence of apatite, fluorine and malladrite phases. The overall findings of the leaching tests showed that PG could be considered as non-hazardous material according to US Environmental Protection Agency limitations. However, a high leachability of elements at a L/S of 2 under acidic conditions ([Ca] = 166.52-199.87 mg/L, [S] = 207.9-233.59 mg/L, [F] = 248.62-286.65 mg/L) is observed. The weathering cell test revealed a considerable cumulative concentration over 90 days indicating potential adverse effects on the nearby environment (S: 8000 mg/kg, F: 3000 mg/kg, P: 700 mg/kg). Based on these results, it could be estimated that the surface storage of PG could have a serious impact on the environment. In this context, a simulation model was developed based on weathering cell results showed encouraging results for treating PG leachate using CaO before its disposal. Additionally, PHREEQC was used to analyze the speciation of major elements and calculate mineral phase saturation indices in PG leaching solutions. The findings revealed pH-dependent speciation for Ca, S, P, and F. The study identified gypsum, anhydrite, and bassanite as the key phases governing the dissolution of these elements.

Predicting the leachate generation from wet phosphogypsum stack using a water-balance-analysis based model

Leachate from wet phosphogypsum (PG) stack should be properly managed to mitigate the negative environmental impact of phosphoric industry. Accurate prediction of leachate amount is the prerequisite for efficient leachate management. In this study, a model using water balance analysis to predict leachate production from wet PG stack is established. The extruded water, which is related to PG deformation, is innovatively introduced as a variable in the model to account for the porewater's contribution. Model simulation suggested that at the early stage, fresh water need to be added to PG to facilitate the transfer or PG slurries; however, as the leachate accumulates in the tailings pond, a net discharge of PG is required starting at the fourth year for the studied PG stack. Model simulation also indicated that the leachate generation increased gradually over time and that the leachate generation in each month could deviate from the average leachate generation during the life cycle of the stack. The model output matches with measured values reasonably well, which confirmed the model's accuracy. Sensitivity analysis indicated that average precipitation and evaporation are the two most important factors that determine leachate generation rate. Monthly leachate generation rates vary significantly within the year, as the precipitation and evaporation vary in different seasons. The highest leachate generation rates were reached in rainy seasons and the lowest rates were reached in wintery months. This study could be used to optimize the PG leachate managements and to mitigate the PG related pollution to the environment.

Potential uses of phosphogypsum: A review

Phosphogypsum (PG) is a by-product of the phosphate fertilizer industry that is produced during the phosphoric acid production process. Annual global PG production ranges between 100 to 300 Mt, with only 15% of that utilized while the rest is usually placed on large dumps with potential serious human and environmental impacts. The aim of this study is to give an overview and to evaluate the existing and potential uses of PG that extend from soil stabilization to cement and chemical industry and for agricultural to geotechnical, human impacts, and environmental applications. More specifically, PG can be used as a substitute in the cement industry, in building materials and in road construction, as a fertilizer for soil improvement, as a raw material for the production of some chemicals, and as a backfilling material for the rehabilitation of abandoned mines and quarries, while the recovery of gypsum and the extraction of rare earth elements signifies the potential importance of PG to cyclic economy. The paper offers an extensive overview of existing and potential uses of PG, discusses their adequacy, and reveals that PG can be widely used under certain conditions, rather than disposed as waste in stockpiles.

As and [Formula: see text] cooccurrence in drinking water: critical review of the international scenario, physicochemical behavior, removal technologies, health effects, and future trends

Drinking water contaminated with As and [Formula: see text] is increasingly prevalent worldwide. Their coexistence can have negative effects due to antagonistic or synergistic mechanisms, ranging from cosmetic problems, such as skin lesions and teeth staining, to more severe abnormalities, such as cancer and neurotoxicity. Available technologies for concurrent removal include electrocoagulation ~ adsorption > membranes > chemical coagulation > , and among others, all of which have limitations despite their advantages. Nevertheless, the existence of competing ions such as silicon > phosphate > calcium ~ magnesium > sulfate > and nitrate affects the elimination efficiency. Mexico is one of the countries that is affected by As and [Formula: see text] contamination. Because only 10 of the 32 states have adequate removal technologies, more than 65% of the country is impacted by co-presence problems. Numerous reviews have been published concerning the elimination of As or [Formula: see text]. However, only a few studies have focused on the simultaneous removal. This critical review analyzes the new sources of contamination, simultaneous physicochemical behaviors, available technologies for the elimination of both species, and future trends. This highlights the need to implement technologies that work with actual contaminated water instead of aqueous solutions (55% of the works reviewed correspond to aqueous solutions). Similarly, it is necessary to migrate to the creation of pilot, pre-pilot, or prototype scale projects, because 77% of the existing studies correspond to lab-scale research.

A critical review of environmental and public health impacts from the activities of evaporation ponds

Evaporation ponds (EVPs) are among the most cost-effective, and simple wastewater treatment technologies used in many regions/countries with high solar radiation levels. However, its operational limitations, which include the overflow of wastewater, leakages via liners, and large surface area of the EVP that is exposed to atmosphere, creates a negative feedback to the environment. Therefore, the main aim of this review study of more than a hundred works published a little all over the continents is to provide a summary of various contaminations that are associated with EVPs activities through different environmental compartments. In addition, the impacts of EVP on fauna, human health including the current on-site sustainable mitigation strategies were also reviewed. The first conclusion from this study shows that the most commonly contaminants released into surface waters, groundwater, soil and sediments were heavy metals, pesticides, herbicides, selenium, including several major anions and cations. Non-methane hydrocarbons (NMHCs), volatile organic compounds (VOCs), and particulate matters (PMs) were the main air pollutants emitted from the surfaces of an EVP. Limited data is available about the emissions of atmospheric greenhouse gas (GHGs) especially carbon dioxide (CO₂) and methane (CH₄) from EVP surfaces. Migratory birds and aquatic organisms are the most vulnerable fauna as EVP wastewaters can cause obstruction of movements, affect diversity, and causes mortalities following the exposure to the toxic wastewater. The study revealed limited data about the potential health risk associated with occupational and environmental exposure to radiological hazards and contaminated drinking water from EVP activities. On-site EVP treatment strategies using bioremediation and electrochemical treatment technologies have shown to be a promising sustainable mitigation approach. Knowledge gaps in areas of GHGs monitoring/modeling, pollution exposure estimation and health risk assessments are urgently required to gain deeper understanding about the impact of EVP activities, and incorporate them into future EVP designs.

Phosphogypsum Recycling: A Review of Environmental Issues, Current Trends, and Prospects

The problem of recycling and storage of phosphogypsum is topical for many countries around the world, as it is associated with environmental problems of pollution of water bodies, land, and atmosphere. Therefore, this paper analyzes the directions of phosphogypsum recycling and possible alternatives to its use. The main disadvantages of the existing methods of phosphogypsum processing were identified and trends in this waste management were also considered. Through the VOSviewer programme, a visualization of cluster interconnections was carried out in research publications of various fields of phosphogypsum utilization. Five clusters were formed: a red cluster—phosphogypsum recycling in the construction industry; green cluster—radiation pollution problem of phosphogypsum and phosphate fertilizers; yellow cluster—monitoring migration of phosphogypsum components in the ecosystem, with the mobile forms of heavy metals and their inflow into aquifers from phosphogypsum dumps; blue cluster—use of phosphogypsum in agriculture as an ameliorant and a component of fertilizer; and a purple cluster—the impact of phosphogypsum on microorganisms, particularly in bioremediation processes. Under the proposed integrated biochemical approach, the use of various bioprocesses of phosphogypsum recovery from waste dumps and implementation of new biotechnological solutions for processing phosphorus raw materials are presented.