Efficacy of Indigenously Prepared Sugarcane and Pineapple Wine Solvents for Washing Highly Dioxin-Contaminated Field Soils

Ecological risk assessment and corrective actions for dioxin-polluted sediment in a chemical plant's brine water storage pond

Despite the known high toxicity of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs, or dioxins), there are few case studies of PCDD/Fs contamination in sediment and there remains much to learn regarding their ecological impact. In this study, we performed an environmental risk assessment of a brine water storage pond near a chemical plant with high PCDD/Fs pollution potential before and after corrective actions. We found PCDD/F accumulation in the pond's fish and crab from the brine water storage pond, and the PCDD/Fs concentrations in biota higher than Taiwan's food safety standard (3.5 pg-TEQ/g). Furthermore, we found a high degree of pollution using different indices, including contamination factor (CF), modified degree of contamination (mCd), and pollution index (PI), in the pond's sediment. Before corrective actions, we also found high risk in the PCDD/F contamination in the sediment using various biological risk indices, including potential ecological risk index (RI) and risk quotient (RQ). After the corrective actions, including institutional/engineering control and remediation, the CF, mCd, and PI had decreased by 20-41 % and RI and RQ by 41-56 %. In addition, despite the slight reduction of pollution and risk index values in the whole pond, significant reduction was observed in the sediment of highly polluted area A owing to the lower disturbing suction dredging. In conclusion, the corrective actions used in this study helped decrease the pollution and ecological risk associated with this site's PCDD/Fs polluted sediment to some extent, suggesting that contamination and risk could be reduced to acceptable levels if these corrective actions are continued.

Combination of Soxhlet extraction and catalytic hydrodebromination for remediation of tetrabromobisphenol A contaminated soil

As a widely used brominated flame retardants (BFRs), tetrabromobisphenol A (TBBPA) has been detected in various environmental matrices and is known to cause negative effects on both the environment and human health. In this study, a combined method was developed for the abatement of TBBPA contaminated soil based on successive steps of solvent extraction (SE) and catalytic hydrodebromination (HDB) over Pd/C. The results showed that TBBPA could be efficiently extracted from the TBBPA contaminated soil with polar solvents. Subsequently, TBBPA could be completely hydrodebrominated over Pd/C in ethanol, via multistep ultimately yielding bisphenol A. Moreover, NaOH, NH₃H₂O, and Et₃N were more favorable to promote the HDB of 4-TBBPA over Pd/C, and 100% bromide atom removal ratio of TBBPA was achieved within 40 min when [NaOH]₀/[organic-Br]₀ was more than 1.10 in ethanol. However, the catalytic activity of Pd/C decreased with the repeated use in ethanol. To study the mechanism for this phenomenon, fresh and used catalysts were analyzed by characterization techniques including scanning electron microscope (SEM), transmission electron microscope (TEM), X-ray photoelectron spectroscopy (XPS), and energy dispersive X-ray spectrometer (EDS). It was found that the deactivation of Pd/C catalyst caused by the gradual accumulation of NaBr could be recovered by washing with water. On the basis of these studies, an effective and practical system for the combined method of SE and catalytic HDB over Pd/C was developed to dispose BFRs contaminated soils.

Research Progress on Heavy Metals Pollution in the Soil of Smelting Sites in China

Contamination by heavy metals is a significant issue worldwide. In recent decades, soil heavy metals pollutants in China had adverse impacts on soil quality and threatened food security and human health. Anthropogenic inputs mainly generate heavy metal contamination in China. In this review, the approaches were used in these investigations, focusing on geochemical strategies and metal isotope methods, particularly useful for determining the pathway of mining and smelting derived pollution in the soil. Our findings indicate that heavy metal distribution substantially impacts topsoils around mining and smelting sites, which release massive amounts of heavy metals into the environment. Furthermore, heavy metal contamination and related hazards posed by Pb, Cd, As, and Hg are more severe to plants, soil organisms, and humans. It's worth observing that kids are particularly vulnerable to Pb toxicity. And this review also provides novel approaches to control and reduce the impacts of heavy metal pollution. Hydrometallurgy offers a potential method for extracting metals and removing potentially harmful heavy metals from waste to reduce pollution. However, environmentally friendly remediation of contaminated sites is a significant challenge. This paper also evaluates current technological advancements in the remediation of polluted soil, such as stabilization/solidification, natural attenuation, electrokinetic remediation, soil washing, and phytoremediation. The ability of biological approaches, especially phytoremediation, is cost-effective and favorable to the environment.

Soil washing for the remediation of dioxin-contaminated soil: A review

Dioxin-contaminated soil has attracted worldwide attention due to its potential negative impacts on human health and the ecosystem. Thus, technological development aiming at high treatment efficiency and low cost for dioxin-contaminated soil is largely needed. In this review, approximately 200 documents were involved to summarize up-to-date scientific achievements of soil washing technology for the remediation of dioxin-contaminated soil. The mechanisms, advantages, and limitations of physical separation techniques (e.g. mechanical stirring, mechanical shaking, ultrasonication, and froth flotation) and washing solutions (e.g. organic solvents, edible oils, and surfactants) used for chemical extraction were comprehensively reviewed. Froth flotation is very promising for field-scale soil washing, whereas organic solvents show high removal efficiencies (up to 99%) of dioxins from contaminated soil. Further, the combination of physical separation and chemical extraction can help enhance dioxin removal efficiency (from 1.5 to 2 times), reducing energy consumption and cost (about 2 times). Among available remediation technologies for dioxin-contaminated soil, soil washing is truly promising since it has shown high removal efficiency (66-99% different remediation scales) with reasonable cost (46 - 250 USD per metric ton). However, the washed solution and volatile organic compounds generated during the process remain a concern and should be addressed in future research.

Ultrasound-assisted soil washing processes using organic solvents for the remediation of PCBs-contaminated soils

Ultrasonic soil washing processes using organic solvents were investigated for the development of novel remediation technologies for persistent organic pollutants (POPs)- contaminated soils. Aluminum foil erosion was first tested to understand sonophysical activity in water, methanol (polar) and n-hexane (nonpolar) in a 28 kHz double-bath-type sonoreactor. Significant sonophysical damage on the aluminum foil was observed at the antinodes for all solvents, and the order of degree of sonophysical damage was as follows: water > methanol > n-hexane. Subsequently, conventional (mechanical mixing only) and ultrasonic soil washing (mechanical mixing and ultrasound) techniques were compared for the removal of polychlorinated biphenyls (PCBs) from soil. Two types of contaminated soils, fresh (Soil A, C0 = 2.5 mg/kg) and weathered (Soil B, C0 = 0.5 mg/kg), were used and the applied soil-to-liquid (S:L) ratio was 1:5 and 1:10 for methanol and n-hexane, respectively. The polar solvent significantly increased washing efficiencies compared to the nonpolar solvent, despite the nonpolar nature of the PCBs. Washing efficiency was significantly enhanced in ultrasonic soil washing compared to conventional washing, owing to macro- and micro-scale sonophysical actions. The highest washing efficiencies of 90% for Soil A and 70% for Soil B were observed in the ultrasonic washing processes using methanol. Additionally, a single operation of the ultrasonic washing process was superior to two sequential processes with conventional mixing in terms of washing efficiency, consumption of washing agents, treatment of washing leachate, and operation time. Finally, the removal of PCBs in an organic solvent (methanol) was investigated in photolytic and sonolytic processes for the post-treatment of soil washing leachate. A photolysis efficiency of 80% was obtained within 60 min of UV exposure for intensities of 1.0, 2.0, and 4.0 W/cm2. The primary mechanism of PCBs degradation is photolytic dechlorination. In contrast, no degradation was detected in the sonolytic process, as the excess organic solvent acted as a strong radical scavenger.

Establishing the relationship between molecular biomarkers and biotransformation rates: Extension of knowledge for dechlorination of polychlorinated dibenzo-p-dioxins and furans (PCDD/Fs)

Anaerobic reductive treatment technologies offer cost-effective and large-scale treatment of chlorinated compounds, including polychlorinated dibenzo-p-dioxins and furans (PCDD/Fs). The information about the degradation rates of these compounds in natural settings is critical but difficult to obtain because of slow degradation processes. Establishing a relationship between biotransformation rate and abundance of biomarkers is one of the most critical challenges faced by the bioremediation industry. When solved for a given contaminant, it may result in significant cost savings because of serving as a basis for action. In the current review, we have summarized the studies highlighting the use of biomarkers, particularly DNA and RNA, as a proxy for reductive dechlorination of chlorinated ethenes. As the use of biomarkers for predicting biotransformation rates has not yet been executed for PCDD/Fs, we propose the extension of the same knowledge for dioxins, where slow degradation rates further necessitate the need for developing the biomarker-rate relationship. For this, we have first retrieved and calculated the bioremediation rates of different PCDD/Fs and then highlighted the key sequences that can be used as potential biomarkers. We have also discussed the implications and hurdles in developing such a relationship. Improvements in current techniques and collaboration with some other fields, such as biokinetic modeling, can improve the predictive capability of the biomarkers so that they can be used for effectively predicting biotransformation rates of dioxins and related compounds. In the future, a valid and established relationship between biomarkers and biotransformation rates of dioxin may result in significant cost savings, whilst also serving as a basis for action.

Characteristics of PCDD/Fs in soil and sediment samples collected from A-So former airbase in Central Vietnam

A-So airbase, located in A-Luoi Valley - Central Vietnam, is a former military base occupied by US Special Forces between 1963 and 1966. The storage of Agent Orange in A-So airbase during the Vietnam War now poses a high potential for PCDD/F contamination in soils and sediments. In order to evaluate the occurrence and characteristics of PCDD/Fs in A-So former airbase, which has been reserved for a long time and suffered almost no significant anthropogenic impacts, soil and sediment samples were collected from 40 sites of two adjacent zones A and B in an area of 160,000 m². Seventeen 2,3,7,8-substituted PCDD/Fs were analyzed using HRCG/HRMS (US EPA method 1613). Results indicate that concentrations of PCDD/Fs measured in zone A ranged from 95.0 to 4534 ng kg_dw^-1 (4.58 to 746 ng TEQ kg_dw^-1), while those in zone B were in the range of 80.8-4150 ng kg_dw^-1 (2.70-89.0 ng TEQ kg_dw^-1). The concentrations of PCDD/Fs observed in zone A are higher than those in zone B, suggesting that PCDD/Fs could be transported from zone A to zone B through surface soil erosion and runoff events. The main contributor to the total TEQ concentration was 2,3,7,8-TCDD, which was the indicator of Agent Orange contamination, accounting for 91 ± 9% and 72 ± 17% of the total TEQ concentrations measured in zones A and B, respectively. Comparison of PCDD/F concentrations in different soil layers reveals that the topsoil layer (at depth < 1 m) contributed 81-95% to the total PCDD/Fs in the study area, indicating that future remediation projects should focus on this topsoil layer. Since PCDD/F contamination in A-So airbase has not significantly improved for the last 20 years, remediation projects are urgently needed in order to mitigate the negative impacts of PCDD/F contamination on human health and wellbeing.