Combined Effect of Nitrofurantoin and Plant Surfactant on Bacteria Phospholipid Membrane

Saponaria officinalis saponins as a factor increasing permeability of Candida yeasts' biomembrane

Saponins are a large group of compounds, produced mostly by plants as a side product of their metabolic activity. These compounds have attracted much attention over the years mostly because of their surface activity and antibacterial, anti-inflammatory and antifungal properties. On the other hand, most of the hitherto research has concerned the action of saponins against microbial cells as a whole. Therefore, knowing the possible interaction of saponins with biomembrane, we decided to check in-vitro the influence of saponin-rich extract of Saponaria officinalis on spheroplasts of two Candida sp. The obtained results show that 10 mg L- 1 of extract increased the permeability of spheroplasts up to 21.76% relative to that of the control sample. Moreover, the evaluation of surface potential has revealed a decrease by almost 10 mV relative to that of the untreated samples. Such results suggest its direct correlation to integration of saponins into the biomembrane structure. The obtained results have proved the antifungal potential of saponins and their ability of permeabilization of cells. This proves the high potential of saponins use as additives to antifungal pharmaceutics, which is expected to lead to improvement of their action or reduction of required dosage.

Biotransformation of sulfamethoxazole by newly isolated surfactant-producing strain Proteus mirabilis sp. ZXY4: Removal efficiency, pathways, and mechanisms

In this study, the SMX degrading strain Proteus mirabilis sp. ZXY4 with surfactant manufacturing potential was isolated from sludge utilizing blood agar and CTAB agar plate. FTIR analysis indicated that the biosurfactant generated by strain ZXY4 was glycolipid. 3D-EEM demonstrated that SMX biodegradation was strongly connected to biosurfactants, the synergistic effect of biodegradation and biosurfactant made strain ZXY4 have excellent SMX degradation performance. Under the optimal conditions of inoculation dosage of 15%, temperature of 30 ℃, pH of 7 and initial SMX concentration of 5 mg L^-1, strain ZXY4 could completely degrade SMX within 24 h. SMX biodegrades at low concentrations (less than5 mg L^-1) followed by the zero-order kinetic model, high concentration (>5 mg L^-1) is more consistent with the first-order kinetic model. LC-MS analysis revealed 14 SMX degradation intermediates, and five potential biodegradation mechanisms were postulated. The findings provide new insights into the biodegradation of SMX.

Co-interaction of nitrofuran antibiotics and the saponin-rich extract on gram-negative bacteria and colon epithelial cells

Large-scale use of nitrofurans is associated with a number of risks related to a growing resistance to these compounds and the toxic effects following from their increasing presence in wastewater and the environment. The aim of the study was to investigate an impact of natural surfactant, saponins from Sapindus mukorossi, on antimicrobial properties of nitrofuran antibiotics. Measurements of bacterial metabolic activity indicated a synergistic bactericidal effect in samples with nitrofurantoin or furazolidone, to which saponins were added. Their addition led to more than 50% greater reduction in viable cells than in the samples without saponins. On the other hand, no toxic effect against human colon epithelial cell was observed. It was found that exposure to antibiotics and surfactants caused the cell membranes to be dominated by branched fatty acids. Moreover, the presence of saponins reduced the hydrophobicity of the cell surface making them almost completely hydrophilic. The results have confirmed a high affinity of saponins to the cells of Pseudomonas strains. Their beneficial synergistic effect on the action of antibiotics from the nitrofuran group was also demonstrated. This result opens promising prospects for the use of saponins from S. mukorossi as an adjuvant to reduce the emission of antibiotics into the environment.

Study of Interactions between Saponin Biosurfactant and Model Biological Membranes: Phospholipid Monolayers and Liposomes

The aim of this study was to determine the effect of saponins-rich plant extract on two model biological membranes: phospholipid monolayers and liposomes. The Langmuir monolayer technique was used to study the interactions of model phospholipid membranes with saponins. The π-A isotherms were determined for DPPE (1,2-dipalmitoyl-sn-glycero-3-phosphoethanolamine) monolayer with the addition of various concentrations of licorice saponins extracts and subjected to qualitative as well as quantitative analysis. Additionally, relaxation studies of the obtained monolayers were carried out and morphological changes were examined using Brewster angle microscopy. Moreover, changes in the structure of phospholipid vesicles treated with solutions of saponins-rich plant extracts were assessed using the FTIR technique. The size and zeta potential of the liposomes were estimated based on DLS methods. The obtained results indicated that the saponins interact with the phospholipid membrane formed by DPPE molecules and that the stability of the mixed DPPE/saponins monolayer strongly depends on the presence of impurities in saponins. Furthermore, it was found that the plant extract rich in saponins biosurfactant interacts mainly with the hydrophilic part of liposomes.

Lipid Flip-Flop-Inducing Antimicrobial Phytochemicals from Gymnema sylvestre are Bacterial Membrane Permeability Enhancers

An amphiphilic phytochemical fraction isolated from methanol extract of Gymnema sylvestre leaf powder contained six terpenoids, two flavonoids, and one alkaloid that induced rapid flip-flop of fluorescent phospholipid analog in the phosphatidyl choline bilayer. Lipid-flipping activity of the methanol-extracted fraction of G. sylvestre (MEFGS) was dose-dependent and time-dependent with a rate constant k = (12.09 ± 0.94) mg^-1 min^-1 that was saturable at (40 ± 1) % flipping of the fluorescent lipid analogue. Interactions of MEFGS phytochemicals with large unilamelar vesicles led to time-dependent change in their rounded morphology into irregular shapes, indicating their membrane-destabilizing activity. MEFGS exhibited antibacterial activity on Escherichia coli (MTCC-118), Staphylococcus aureus (MTCC-212), and Pseudomonas aeruginosa (MTCC-1035) with IC₅₀ values 0.5, 0.35, and 0.1 mg/mL, respectively. Phytochemicals in MEFGS increased membrane permeabilization in all three bacteria, as indicated by 23, 17, and 17% increase in the uptake of crystal violet, respectively. MEFGS enhanced membrane damage, resulting in a 3-5 fold increase in leakage of cytosolic ions, 0.5-2 fold increase in leakage of PO₄ ^-, and 15-20% increase in loss of cellular proteins. MEFGS synergistically increased the efficacy of curcumin, amoxillin, ampicillin, and cefotaxime on S. aureus probably by enhancing their permeability into the bacterium. For the first time, our study reveals that phytochemicals from G. sylvestre enhance the permeability of the bacterial plasma membrane by facilitating flip-flop of membrane lipids. Lipid-flipping phytochemicals from G. sylvestre can be used as adjuvant therapeutics to enhance the efficacy of antibacterials by increasing their bioavailability in the target bacteria.

The Enhancement of the Photodynamic Therapy and Ciprofloxacin Activity against Uropathogenic Escherichia coli Strains by Polypodium vulgare Rhizome Aqueous Extract

Antibiotic therapy and photodynamic therapy (PDT) are commonly used to treat bacterial infections. Unfortunately, these methods are often ineffective. Therefore, agents that could effectively support antibiotic therapy and PDT in the inactivation of pathogens are being sought. Phytotherapy seems to be a good solution. The aim of the current research was to examine whether Polypodium vulgare extract (PvE) would improve the effectiveness of PDT and ciprofloxacin (CIP), an antibiotic that is commonly used to treat urinary tract infections in humans. UHPLC-MS analysis was performed to establish the PvE content. Chlorin e6 has been used as a photosensitizer in the PDT method. Biofilm production was established using the spectrophotometric method. The live cell count in planktonic and biofilm consortia was determined with the microdilution method and DAPI staining. The decrease of the bacterial survival, biofilm mass synthesis, and morphological changes of the bacteria under the combined treatments: PDT+PvE and CIP+PvE was noted. The results clearly indicate that the PvE can be used as a good agent for improving the efficacy of both PDT and the CIP activity to inactivate uropathogenic Escherichia coli strains. The obtained results are of particular value in the era of widespread and still-increasing drug resistance among bacterial pathogens.

Langmuir Monolayer Techniques for the Investigation of Model Bacterial Membranes and Antibiotic Biodegradation Mechanisms

The amounts of antibiotics of anthropogenic origin released and accumulated in the environment are known to have a negative impact on local communities of microorganisms, which leads to disturbances in the course of the biodegradation process and to growing antimicrobial resistance. This mini-review covers up-to-date information regarding problems related to the omnipresence of antibiotics and their consequences for the world of bacteria. In order to understand the interaction of antibiotics with bacterial membranes, it is necessary to explain their interaction mechanism at the molecular level. Such molecular-level interactions can be probed with Langmuir monolayers representing the cell membrane. This mini-review describes monolayer experiments undertaken to investigate the impact of selected antibiotics on components of biomembranes, with particular emphasis on the role and content of individual phospholipids and lipopolysaccharides (LPS). It is shown that the Langmuir technique may provide information about the interactions between antibiotics and lipids at the mixed film surface (π–A isotherm) and about the penetration of the active substances into the phospholipid monolayer model membranes (relaxation of the monolayer). Effects induced by antibiotics on the bacterial membrane may be correlated with their bactericidal activity, which may be vital for the selection of appropriate bacterial consortia that would ensure a high degradation efficiency of pharmaceuticals in the environment.

Aesculus hippocastanum L. as a Stabilizer in Hemp Seed Oil Nanoemulsions for Potential Biomedical and Food Applications

Nanoemulsion systems receive a significant amount of interest nowadays due to their promising potential in biomedicine and food technology. Using a two-step process, we produced a series of nanoemulsion systems with different concentrations of hemp seed oil (HSO) stabilized with Aesculus hippocastanum L. extract (AHE). Water and commercially-available low-concentrated hyaluronic acid (HA) were used as the liquid phase. Stability tests, including an emulsifying index (EI), and droplet size distribution tests performed by dynamic light scattering (DLS) proved the beneficial impact of AHE on the emulsion’s stability. After 7 days of storage, the EI for the water-based system was found to be around 100%, unlike the HA systems. The highest stability was achieved by an emulsion containing 5% HSO and 2 g/L AHE in water, as well as the HA solution. In order to obtain the detailed characteristics of the emulsions, UV-Vis and FTIR spectra were recorded, and the viscosity of the samples was determined. Finally, a visible microscopic analysis was used for the homogeneity evaluation of the samples, and was compared with the DLS results of the water system emulsion, which showed a desirable stability. The presented results demonstrate the possible use of oil emulsions based on a plant extract rich in saponins, such as AHE. Furthermore, it was found that the anti-inflammatory properties of AHE provide opportunities for the development of new emulsion formulations with health benefits.