Ultrasonic treatment of dye chemicals in wastewater: A review

The existence of pollutants, such as toxic organic dye chemicals, in water and wastewater raises concerns as they are inadequately eliminated through conventional water and wastewater treatment methods, including physicochemical and biological processes. Ultrasonic treatment has emerged as an advanced treatment process that has been widely applied to the decomposition of recalcitrant organic contaminants. Ultrasonic treatment has several advantages, including easy operation, sustainability, non-secondary pollutant production, and saving energy. This review examines the elimination of dye chemicals and categorizes them into cationic and anionic dyes based on the existing literature. The objectives include (i) analyzing the primary factors (water quality and ultrasonic conditions) that influence the sonodegradation of dye chemicals and their byproducts during ultrasonication, (ii) assessing the impact of the different sonocatalysts and combined systems (with ozone and ultraviolet) on sonodegradation, and (iii) exploring the characteristics-based removal mechanisms of dyes. In addition, this review proposes areas for future research on ultrasonic treatment of dye chemicals in water and wastewater.

A fundamental study on the degradation of paracetamol under single- and dual-frequency ultrasound

The degradation of paracetamol, a widely found emerging pharmaceutical contaminant, was investigated under a wide range of single-frequency and dual-frequency ultrasonic irradiations. For single-frequency ultrasonic irradiation, plate transducers of 22, 98, 200, 300, 400, 500, 760, 850, 1000, and 2000 kHz were employed and for dual-frequency ultrasonic irradiation, the plate transducers were coupled with a 20 kHz ultrasonic horn in opposing configuration. The sonochemical activity was quantified using two dosimetry methods to measure the yield of HO• and H₂O₂ separately, as well as sonochemiluminescence measurement. Moreover, the severity of the bubble collapses as well as the spatial and size distribution of the cavitation bubbles were evaluated via sonoluminescence measurement. The paracetamol degradation rate was maximised at 850 kHz, in both single and dual-frequency ultrasonic irradiation. A synergistic index higher than 1 was observed for all degrading frequencies (200 - 1000 kHz) under dual-frequency ultrasound irradiation, showing the capability of dual-frequency system for enhancing pollutant degradation. A comparison of the results of degradation, dosimetry, and sonoluminescence intensity measurement revealed the stronger dependency of the degradation on the yield of HO• for both single and dual-frequency systems, which confirms degradation by HO• as the main removal mechanism. However, an enhanced degradation for frequencies higher than 500 kHz was observed despite a lower HO• yield, which could be attributed to the improved mass transfer of hydrophilic compounds at higher frequencies. The sonoluminescence intensity measurements showed that applying dual-frequency ultrasonic irradiation for 200 and 400 kHz made the bubbles larger and less uniform in size, with a portion of which not contributing to the yield of reactive oxidant species, whereas for the rest of the frequencies, dual-frequency ultrasound irradiation made the cavitation bubbles smaller and more uniform, resulting in a linear correlation between the overall sonoluminescence intensity and the yield of reactive oxidant species.

Sonochemical synthesis and structural characterization of an organic-inorganic nanohybrid based on a copper-dithiocarbamate complex and PMo12O403- polyanion as a novel sonocatalyst

A new organic-inorganic nanohybrid compound, ([Cu{(HOCH₂CH₂)₂NCS₂}₂]₃[PMo₁₂O₄₀] (1)), has been prepared by sonochemical technique using copper(II) dithiocarbamate complex and a Keggin-type polyoxomolybdate in this research. FT-IR, XRD, FE-SEM, TEM, EDX, UV-Vis, TGA, BET, and single crystal XRD analyses were applied to describe the properties of the composition of the nanohybrid. Compound (1) is composed of [PMo₁₂O₄₀]^3- building blocks and [Cu{(HOCH₂CH₂)₂NCS₂}₂]¹⁺ cationic moieties, and electrostatic forces and substantial hydrogen-bonding interactions were applied to pack them; and consequently, a three dimensional supramolecular framework was made based on single-crystal X-ray diffraction patterns. FE-SEM and TEM images approved the morphology of the nanohybrid sample to be extremely penetrable. Very good sonocatalytic performance is shown by this supramolecular nanohybrid in the degradation of Rhodamine B (RhB), which is a cationic organic dye. The results showed complete degradation of cationic RhB (25 mg/L) within 70 min with the rate constant of 0.039min^-1 in the presence of nanohybrid (1) and H₂O₂ (4 mmol/L). Also, sonocatalytic activity of the nanohybrid (1) was higher than H₃PMo₁₂O₄₀, showing that the combining Cu(DEDTC)₂ complex with H₃PMo₁₂O₄₀ could be an excellent choice to improve its sonocatalytic activity. The used nanohybrid (1) can be recycled after easily removing from the reaction media by centrifuging, and there was no considerable loss of catalytic activity and retention of the structure.

Degradation of methylparaben by sonocatalysis using a Co-Fe magnetic carbon xerogel

The degradation of methylparaben (MP) through 20 kHz ultrasound coupled with a bimetallic Co-Fe carbon xerogel (CX/CoFe) was investigated in this work. Experiments were performed at actual power densities of 25 and 52 W/L, catalyst loadings of 12.5 and 25 mg/L, MP concentrations between 1 and 4.2 mg/L and initial pH values between 3 and 10 in ultrapure water (UPW). Matrix effects were studied in bottled water (BW) and secondary treated wastewater (WW), as well as in UPW spiked with bicarbonate, chloride or humic acid. The pseudo-first order kinetics of MP degradation increase with power and catalyst loading and decrease with MP concentration and matrix complexity; moreover, the reaction is also favored at near-neutral conditions and in the presence of dissolved oxygen. The contribution of the catalyst is synergistic to the sonochemical degradation of MP and the extent of synergy is quantified to be >45%. This effect was ascribed to the ability of CX/CoFe to catalyze the dissociation of hydrogen peroxide, formed through water sonolysis, to hydroxyl radicals. Experiments in UPW spiked with an excess of tert-butanol (radical scavenger), sodium dodecyl sulfate or sodium acetate (surfactants) led to substantially decreased rates (i.e. by about 8 times), thus implying that the liquid bulk and the gas-liquid interface are major reaction sites. The stability of CX/CoFe was shown by performing reusability cycles employing magnetic separation of the catalyst after the treatment stage. It was found that the CX/CoFe catalyst can be reused in up to four successive cycles without noteworthy variation of the overall performance of the sonocatalytic process.

Synthesis and sonocatalytic performance of a ternary magnetic MIL-101(Cr)/RGO/ZnFe2O4 nanocomposite for degradation of dye pollutants

In this study, new ternary magnetic MIL-101(Cr)/RGO/ZnFe₂O₄ catalyst (with 30% wt of ZnFe₂O₄) was synthesized via a hydrothermal route for sonodegradation of organic dyes. The structural, optical and magnetic properties of the nanocomposite were detected by means of X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), UV-visible spectroscopy (UV-visible), field emission scanning electron microscopy (FESEM), energy dispersive X-ray (EDX) spectroscopy, vibrating sample magnetometer (VSM), atomic force microscopy (AFM), Raman spectroscopy and BET surface area analysis. To evaluate the sonocatalytic activity of the as-prepared MIL-101(Cr)/RGO/ZnFe₂O₄ nanocomposite, the H₂O₂-assisted degradation of organic dyes such as congo red (CR), methylene blue (MB), Rhodamine B (RhB) and methyl orange (MO) in aqueous solution was studied under ultrasound irradiation. The obtained results indicated that the ternary MIL-101(Cr)/RGO/ZnFe₂O₄ nanocomposite had better performance for sonodegradation of these dyes than MIL-101(Cr)/RGO, pure MIL-101(Cr) or ZnFe₂O₄. The enhanced sonocatalytic performance of the as-prepared ternary nanocomposite could be attributed to the fast generation and separation of charge carriers (electrons and holes) in ZnFe₂O₄and MIL-101(Cr) and their transfer to the surface of graphene sheets. Moreover, the relatively high specific surface area of the MIL-101(Cr)/rGO and magnetic property of ZnFe₂O₄ improve the degradation efficiency of the dyes. The recovery of the ternary magnetic sonocatalyst from treated water could be easily achieved using an external magnetic field. The main influence factors on the sonocatalytic activity such as catalyst dosage and dye initial concentration were also investigated. The trapping experiments indicated that OH radicals are the prominent active species in dye degradation. In addition, the reusability test, was also carried out to ensure the stability of the employed sonocatalyst.

Modification of nanosized natural montmorillonite for ultrasound-enhanced adsorption of Acid Red 17

This work aims to modify montmorillonite (MMT) via dodecyltrimethylammonium bromide (DTMA) and investigate its ability in ultrasound (US) assisted decolorization of a polluted solution. BET surface area of MMT was increased from 19.76 to 42.57 m(2)/g and basal spacing of MMT structural layers was increased from 1.13 to 1.69 nm by DTMA modification. The application of DTMA-modified MMT (DTMA-MMT) and US for the decolorization of Acid Red 17 (AR17) showed that US could improve the ability of DTMA-MMT on decolorization of AR17 solution due to simultaneous adsorption and sonocatalysis. The ability of US assisted DTMA-MMT was slightly decreased with pH, the initial dye concentration and the presence of inorganic anions.

Sonochemical degradation of ethyl paraben in environmental samples: Statistically important parameters determining kinetics, by-products and pathways

The sonochemical degradation of ethyl paraben (EP), a representative of the parabens family, was investigated. Experiments were conducted at constant ultrasound frequency of 20 kHz and liquid bulk temperature of 30 °C in the following range of experimental conditions: EP concentration 250-1250 μg/L, ultrasound (US) density 20-60 W/L, reaction time up to 120 min, initial pH 3-8 and sodium persulfate 0-100mg/L, either in ultrapure water or secondary treated wastewater. A factorial design methodology was adopted to elucidate the statistically important effects and their interactions and a full empirical model comprising seventeen terms was originally developed. Omitting several terms of lower significance, a reduced model that can reliably simulate the process was finally proposed; this includes EP concentration, reaction time, power density and initial pH, as well as the interactions (EP concentration)×(US density), (EP concentration)×(pHo) and (EP concentration)×(time). Experiments at an increased EP concentration of 3.5mg/L were also performed to identify degradation by-products. LC-TOF-MS analysis revealed that EP sonochemical degradation occurs through dealkylation of the ethyl chain to form methyl paraben, while successive hydroxylation of the aromatic ring yields 4-hydroxybenzoic, 2,4-dihydroxybenzoic and 3,4-dihydroxybenzoic acids. By-products are less toxic to bacterium V. fischeri than the parent compound.

Synthesis and sonocatalytic property of rod-shape Sr(OH)2·8H2O

A novel rod-shape sonocatalyst Sr(OH)2·8H2O was prepared by a facile precipitation method, and characterized by X-ray powder diffraction, transmission electron microscopy, Fourier transform infrared spectroscopy and UV-vis absorption spectroscopy. Comparative sonocatalytic degradation experiments were carried out in different conditions under ultrasonic irradiation by using rhodamine B (RhB) as the model substrate, indicating that Sr(OH)2·8H2O was highly sonocatalytic. Total organic carbon experiment demonstrated Sr(OH)2·8H2O with mass mineralization of organic carbon. The effects of catalyst amount, initial RhB concentration and ultrasonic energy of degradation were investigated, and the sonocatalyst could be reused 5 times without significant loss of activity. Furthermore, the potent degrading capability was ascribed to ultrasonic cavitation producing flash light/energy which generated radicals (e.g., OH) with high oxidation activity.

Fabrication and sonocatalytic property of AgPO3 microsphere

AgPO3 microspheres were prepared by a simple hydrothermal method. The AgPO3 microspheres were characterized by X-ray powder diffraction (XRD), scanning electronic microscopy (SEM), Brunauer-Emmett-Teller (BET), UV-vis absorption spectroscopy (UV-vis), and photoluminescence (PL) measurement. SEM reveals that the AgPO3 microspheres were constructed by the accumulation of small particles. The as-prepared AgPO3 microspheres sonocatalytically degraded Rhodamine B (RhB) excellently under ultrasonic irradiation. The sonocatalytic ability results from the OH radicals induced by AgPO3 microspheres under ultrasonic irradiation. The effects of other conditions on ultrasonic activity were also investigated. The content of OH radicals in the reaction system was determined to further verify the above conclusions.