Determination of β-lactam residues in foodstuffs of animal origin using supported liquid membrane extraction and liquid chromatography–mass spectrometry

Veterinary Drug Residues in Food Products of Animal Origin and Their Public Health Consequences: A Review

Veterinary medications used for disease treatment and prevention may remain in animal-origin foods, such as milk, eggs, honey and meat, which could pose a risk to the public's health. These drugs come from different groups of drugs, mostly with antibiotic, anti-parasitic or anti-inflammatory actions, in a range of food matrices including milk, meat or egg. This review is intended to provide the reader with a general insight about the current status of veterinary drug residues in food products of animal origin, detection methods and their public health consequences. The discovery of antimicrobials has led to the development of antibiotics for treating and preventing cattle illnesses and encouraging growth. However, the rise of drug resistance has led to increased antibiotic consumption and resistance among microbes in the animal habitat. This resistance can be passed to humans directly or indirectly through food consumption and direct or indirect interaction. Improper and illegal use, inadequate withdrawal periods and environmental contamination from veterinary drugs are reported to be the major causes for the formation of residue in food products of animal origin. The use of veterinary products above or below the advised level may also result in short- or long-term public health issues, such as the creation of resistant strains of micro-organisms, toxicity, allergy, mutagenesis, teratogenicity and carcinogenetic effects. To ensure consumer safety, veterinary drug residues in food must be under control.

Electromembrane extraction - capillary zone electrophoresis for the quantitative determination of β-lactam antibiotics in milk samples

Three penicillin-based β-lactam antibiotics (benzylpenicillin, amoxicillin, and ampicillin) were extracted by electromembrane extraction (EME) and determined in the resulting extracts by capillary zone electrophoresis (CZE) with UV-Vis detection. The EME was optimized for the simultaneous clean-up of complex samples and preconcentration of the three antibiotics and employed 1-octanol as the organic phase interface (impregnated in the pores of a hollow fiber), acidified donor solution (pH 3), and phosphate buffer (pH 5.6) as the acceptor solution. The EMEs were carried out for 20 min at 300 V and constant stirring (750 rpm) of the donor solution. At the optimized EME-CZE conditions, the sensitivity of the analytical method was sufficient for the determination of the three β-lactam antibiotics in undiluted cow's milk at concentrations below the EU maximum residue limits (4 μg/L) in foodstuffs. The method was simple, rapid, and convenient and offered extraction recoveries of 13.5 - 87.3 %, enrichment factors of 23.6 - 152.8, repeatability (RSD values) better than 7.6 %, linear analytical response in the 1 - 100 μg/L (3 - 100 μg/L for benzylpenicillin) concentration range with correlation coefficients ≥ 0.9997, and limits of detection from 0.2 to 1.2 μg/L. The proposed analytical concept was used for the rapid control of milk quality (i.e. assessment of excessive use of antibiotics in dairy animals), moreover, it was further extended to the trace determination of β-lactam antibiotics in other complex samples, such as in wastewater.

Improving the chromatographic selectivity of β-lactam residue analysis in milk using phenyl-column chemistry prior to detection by tandem mass spectrometry

Analyte isobaric interferences can limit the development of a comprehensive analytical method for the quantitative liquid chromatography-tandem mass spectrometry profiling of an important cohort of veterinary drugs. In this work, a selective chromatographic separation was developed for the analysis of 32 β-lactam antibiotic residues (12 penicillins, 14 cephalosporins, five carbapenems and faropenem) in milk samples. A range of analytical columns with different stationary phases and mobile phases were evaluated for retention and separation of the β-lactam compounds. Results showed that, among the columns tested, only phenyl-hexyl could adequately separate ampicillin from cephalexin and amoxicillin from cefadroxil, which had shown isobaric interferences on a number of stationary phases. Chromatography was performed using a water/acetonitrile binary gradient with formic acid and ammonium acetate. The β-lactam residues were extracted from the milk samples using a water:acetonitrile solution and purified by C₁₈ dispersive solid-phase extraction (d-SPE) clean-up, followed by concentration under nitrogen and ultra-high performance liquid chromatography-tandem mass spectrometry (UHPLC-MS/MS) determination. Analytes were monitored in positive electrospray ionisation mode (ESI(+)). Possible interfering matrix effects were overcome by using 13 internal standards. The method was fully validated according to 2002/657/EC guidelines, showing satisfactory performance characteristics. Under within-laboratory reproducibility conditions, trueness and precision ranged from 91 to 130% and from 1.4 to 38.6%, respectively. Decision limits (CCα) were in the range 2.1-133 μg kg^-1. Limits of detection (LODs) and quantitation (LOQs) ranged between 0.0090 and 1.5 μg kg^-1 and from 0.030 to 5.0 μg kg^-1, respectively.

Flow-injection chemiluminescence determination of cloxacillin in water samples and pharmaceutical preparation by using CuO nanosheets-enhanced luminol-hydrogen peroxide system

In this paper, a rapid and sensitive flow-injection chemiluminescence (flow-CL) system was developed for the determination of cloxacillin sodium in environmental water samples and pharmaceutical preparations. The method was based on the enhancement effect of cloxacillin sodium on the CL reaction of luminal-H₂O₂-CuO nanosheets (NSs) in alkaline medium. The CuO nanosheets were synthesized using a green sonochemical method. The physical properties of the synthesized CuO nanosheets were characterized by X-ray diffraction (XRD) and scanning electron microscopy (SEM) analyses. The influences of various experimental factors such as H₂O₂, NaOH, luminol and CuO nanosheets concentrations were investigated. Under the optimum conditions, the enhanced CL intensity was linearly related to the concentration of cloxacillin sodium in the range of the 0.05-30.00 mg L(-1) with a correlation coefficient of 0.995. The corresponding detection limit (3σ) was calculated to be 0.026 mg L(-1). The relative standard deviation (RSD) of the developed method was 2.21% with 11 repeated measurements of 4.00 mg L(-1) cloxacillin sodium. Also, a total analysis time per sample was 30 s which confirmed the rapidity of the proposed method. The analytical applicability of the proposed CL system was assessed by determining cloxacillin sodium in spiked environmental water samples and pharmaceutical preparation. Furthermore, the possible mechanism of CL reaction was discussed.

Optimisation and validation of a quantitative and confirmatory LC-MS method for multi-residue analyses of β-lactam and tetracycline antibiotics in bovine muscle

A multi-residue method for the determination of the β-lactam antibiotics ampicillin, cefazolin, cloxacillin, dicloxacillin, nafcillin, oxacillin, penicillin G, penicillin V and the tetracyclines chlotetracycline, tetracycline and oxytetracycline was optimised and validated in bovine muscle. The method is based on the extraction of the residues from muscle using water/acetonitrile (2/8, v/v) with subsequent use of dispersive solid-phase C18 and hexane for purification. Extracts were analysed using ultra-performance liquid chromatography (UPLC-MS/MS) coupled with the mass spectrometer in positive electrospray ionisation mode (ESI+) for all analytes. The method was validated according to the requirements of European Commission Decision 2002/657/EC. The validation results were obtained within the MRL range of 0-1.5 of the MRL, with recoveries varying from 90% to 110% and CV < 20% (n = 54), except for cloxacillin, dicloxacillin and nafcillin. However, matrix interference was observed. The decision limit (CCα) ranged from 10% to 15% of the MRL. The uncertainty measurement was estimated based on both bottom-up and top-down strategies and the uncertainty values were found to be lower than 20% of the MRL. The method has a simple extraction procedure whereby analytes are separated with reasonable resolutions in a single 11-min chromatographic run. According to the validation results, this method is suitable for monitoring β-lactams and tetracyclines according to National Program for Residue and Contaminant Control - Brazil (NPRC-Brazil) in bovine muscle.

Determination of penicillins in milk using LC-UV, LC-MS and LC-MS/MS

The aim of this work is to establish a method for the simultaneous determination of eight penicillins in milk samples by LC-UV, LC-MS and LC-MS/MS. The procedure involves a step for clean-up and to preconcentrate the analytes by SPE and a subsequent chromatographic analysis. LC-UV, LC-MS and LC-MS/MS have been used for the simultaneous quantification of penicillins in milk. The proposed methods have been validated according to the EU guideline and present LOQ below the maximum limits of residues (MRLs) established by the European Union for penicillins in milk. The developed methods were applied to different milk samples obtained from cows medicated with penicillins.

Streamlining methodology for the multiresidue analysis of beta-lactam antibiotics in bovine kidney using liquid chromatography-tandem mass spectrometry

A previously reported multiresidue method for the analysis of 11 important beta-lactams (amoxicillin, ampicillin, cefazolin, cephalexin, cloxacillin, desfuroylceftiofur cysteine disulfide (DCCD), deacetylcephapirin, dicloxacillin, nafcillin, oxacillin, and penicillin G) in bovine kidney has been further streamlined. The method is based on a simple extraction using acetonitrile-water (4:1, v/v), followed by dispersive solid-phase extraction clean-up with C(18) sorbent, concentration of an extract aliquot, and filtration of the final extracts using syringeless filter vials, which are used for the sample introduction in the liquid chromatographic-tandem mass spectrometric (LC-MS/MS) analysis. The recoveries have been improved by adding the internal standard [(13)C(6)]sulfamethazine to the homogenized sample before the extraction step, which enabled a proper control of the volume changes during the sample preparation. Average recoveries of fortified samples were 87-103% for all beta-lactams, except for DCCD, which had an average recovery of 60%. Based on the results of the stability study and LC mobile phase tests, methanol has been eliminated from the entire method, including the LC-MS/MS analysis. The best overall LC-MS/MS (electrospray positive ionization) performance was achieved by using 0.1% formic acid as an additive in both parts of the mobile phase, in water and in acetonitrile. To prevent carry-over in the LC-MS/MS analysis, the LC method was divided into two parts: one serving as an analytical method for injection of the sample and elution of the analytes and the other one, starting at a highly organic mobile phase composition, being dedicated for injection of a solvent, washing of the system, and equilibration of the column to the initial conditions of the analytical method. In this way, a blank solvent is injected after each sample, but these in-between injections contribute minimally to the overall sample throughput.

On-line clean-up and screening of oxacillin and cloxacillin in human urine and plasma with a weak ion exchange monolithic column

A weak ion exchange monolithic column prepared by modifying the GMA-MAA-EDMA (glycidyl methacrylate-methacrylic acid-ethylene glycol dimethacrylate) monoliths with ethylenediamine was applied to remove matrix compounds in biological fluid. Using this monolithic column, on-line clean-up and screening of oxacillin and cloxacillin in human urine and plasma samples had been investigated. Chromatography was performed by reversed-phase HPLC on a C(18) column with ultraviolet detection at 225 nm. Results showed that the ion exchange monolithic column could be used for deproteinization and retaining oxacillin and cloxacillin in human urine and plasma, which provided a simple and fast method for assaying drugs in human urine and plasma.

Sample preparation for chromatography: An African perspective

Africa as a continent has its unique challenges for analytical chemists in sample preparation for chromatographic analyses. The areas of agriculture, environment, food and health provide formidable challenges when it comes to method development, for example, drought can result in inadequate supplies of good quality water. The testing of water quality necessitates the development of assay methods that can be employed to not only determine the quantities of pesticides associated with malaria and tsetse fly eradication programmes, but also to monitor mycotoxins or neurotoxins. Urbanisation has also meant that endocrine disruptors such as phthalate esters need to be monitored. This review will profile some of the activities by analytical chemists practising in the African continent, who seek to address some of the challenges in sample preparation for chromatographic analyses.