Automated alkaline-induced salting-out homogeneous liquid-liquid extraction coupled with in-line organic-phase detection by an optical probe for the determination of diclofenac

Ultrasound-assisted switchable hydrophilic solvent-based homogeneous liquid-liquid microextraction for the determination of triazole fungicides in environmental water by GC-MS

A new method was developed for the determination of three triazole fungicides in environmental water samples by gas chromatography-mass spectrometry (GC-MS) based on ultrasonic assisted switchable hydrophilic solvent homogeneous liquid-liquid microextraction. As a switchable hydrophilic solvent, N,N-dimethylcyclohexylamine (DMCHA) does not require a dispersant or centrifugation. Ultrasound assistance is helpful to speed up the extraction of target compounds and can reduce the pretreatment time. The entire pretreatment process of this method only takes 5 minutes. Using the Box-Behnken design as the means of optimization, optimal extraction conditions were obtained through a mathematical model. Good linearity was obtained in the range of 5-500 μg L^-1, and the correlation coefficient of target compounds was greater than 0.999. The matrix spiked recoveries were between 81.3% and 111.1% and the detection limit was between 0.46 and 0.99 μg L^-1. Intraday relative standard deviation (n = 3) was 13.0-13.9% at 100 μg L^-1. Finally, it was concluded that the method is a rapid, efficient and simple method for the analysis of triazole fungicides in water.

Homogeneous liquid-liquid extraction as an alternative sample preparation technique for biomedical analysis

Liquid-liquid extraction is a widely used technique of sample preparation in biomedical analysis. In spite of the high pre-concentration capacities of liquid-liquid extraction, it suffers from a number of limitations including time and effort consumption, large organic solvent utilization, and poor performance in highly polar analytes. Homogeneous liquid-liquid extraction is an alternative sample preparation technique that overcomes some drawbacks of conventional liquid-liquid extraction, and allows employing greener organic solvents in sample treatment. In homogeneous liquid-liquid extraction, a homogeneous phase is formed between the aqueous sample and the water-miscible extractant, followed by chemically or physically induced phase separation. To form the homogeneous phase, aqueous samples are mixed with water-miscible organic solvents, water-immiscible solvents/cosolvents, surfactants, or smart polymers. Then, phase separation is induced chemically (adding salt, sugar, or buffer) or physically (changing temperature or pH). This mode is rapid, sustainable, and cost-effective in comparison with other sample preparation techniques. Moreover, homogeneous liquid-liquid extraction is more suitable for the extraction of delicate macromolecules such as enzymes, hormones, and proteins and it is more compatible with liquid chromatography with tandem mass spectrometry, which is a vital technique in metabolomics and proteomics. In this review, the principle, types, applications, automation, and technical aspects of homogeneous liquid-liquid extraction are discussed.

A fully automated system with an optical immersion probe (OIP) for high-precision spectrophotometric measurements

A new and fully automated system with the interconnection of an Optical Immersion Probe (OIP) - pH meter - peristaltic pump was used to study the spectral and protolytic properties of carbocyanine the dyes 1,1',3,3,3',3'-hexamethylindocarbocyanine chloride (HIC); 1,1',3,3,3',3'-hexamethylindodicarbocyanine iodide (HIDC); and 3,3'-diethyloxadicarbocyanine iodide (DODC). This system can measure a large number of experimental points in a short time period. The effect of 32 various organic solvents on the UV-ViS spectra of the dyes was studied. The solvatochromic behaviour of studied dyes was characterized by positive solvatochromism for HIDC and negative solvatochromism for HIC and DODC. Through the application of a large number of experimental points, the protonation and hydrolysis constants of dyes were determined with high precision, where the confidence interval of the рK values is ±(0.001-0.005), compared with a confidence interval of ±(0.04-0.10) for standard procedures. The fully automated system presented is accurate, fast, environmentally friendly and promising for multiple analytical applications.

Oxidation of diclofenac in the presence of iron(II) octacarboxyphthalocyanine

This paper presents the results of the research on the influence of catalytic activity of iron(II) octacarboxyphthalocyanines (FePcOC) on the transformation of diclofenac (DCF) which is the most popular anti-inflammatory analgesic. Diclofenac poses a serious threat to the natural environment. The paper demonstrates that diclofenac, in the presence a monomeric form of iron octacarboxyphthalocyanine and hydroxyl radicals (HO^•) (from H₂O₂), undergoes a transformation into diclofenac-2,5-iminoquinone (DCF-2,5-IQ), causing distinct changes in the UV-Vis absorption spectrum. In the presence of iron octacarboxyphthalocyanine and H₂O₂, the previously colourless diclofenac solution becomes intense orange. As a result, a new band at approx. 450 nm appears in the absorption spectrum. HPLC analysis has shown that the concentration of diclofenac decreases with time. TD-DFT calculations using the CAM-B3LYP/6-31+G (d, p) method have been conducted to confirm experimental data concerning the formation of a new band at λ_max = 450 nm.

Development of a New Kinetic Spectrophotometric Method for the Determination of Chromium with an Optical Probe

The aim of this work is the development, optimization, and validation of a new spectrophotometric kinetic method for the determination of dissolved chromium species in water samples with the use of the polymethine dye Astra Phloxine FF. The progress of the chemical reaction was simple, effective, and precisely monitored from the start of the reaction using an optical probe. The method is based on the impact of Cr(VI) concentration on the rate of decrease in the Astra Phloxine FF concentration. The experimental data were evaluated using four experimental data analysis methods, namely with the initial rate method, the average rate method, the fixed time method, and the absorption peak volume change method. Under the optimal reaction conditions, the best results were achieved using the method of the average rate constant for evaluating the experimental data. Using this data evaluation method for the determination of Cr(VI), the LoD was found to be 1.87 µg L^-1 and RSD ( n = 6; 0.2 mg L^-1 Cr) 3.59%. The presented work was used for the determination of chromium in model samples-CRM material and tap and waste water-and with the calibration line method and the standard additions method.

An automated salting-out assisted liquid-liquid microextraction approach using 1-octylamine: On-line separation of tetracycline in urine samples followed by HPLC-UV determination

An automated salting-out assisted liquid-liquid microextraction (SALLME) procedure based on a flow system was developed as new approach for pretreatment of complex sample matrix. In this procedure 1-octylamine was investigated as novel extractant for the SALLME. The procedure involved aspiration of the 1-octylamine and sample solution into a mixing chamber of a flow system followed by their air-bubble mixing resulting to isotropic solution formation. To provide phase separation a salting-out agent solution was added into the mixing chamber. After phase separation, the micellar 1-octylamine phase containing analyte was mixed with methanol and transported to a HPLC-UV system. To demonstrate the efficiency of the suggested approach, the automated procedure was applied for the HPLC-UV determination of tetracycline as a proof-of-concept analyte in human urine samples. Under the optimal conditions, the detector response of the analytes was linear in the concentration ranges of 0.5-20 mg L^-1. The limit of detection, calculated from a blank test based on 3σ, was 0.17 mg L^-1. The results demonstrate that the developed approach is highly cost-effective, simple and rapid.

Highly sensitive determination of diclofenac based on resin beads and a novel polyclonal antibody by using flow injection chemiluminescence competitive immunoassay

A novel flow injection chemiluminescence immunoassay for simple, sensitive and low-cost detection of diclofenac was established based on specific binding of antigen and antibody. Carboxylic resin beads used as solid phase carrier materials provided good biocompatibility and large surface-to-volume ratio for modifying more coating antigen. There was a competitive process between the diclofenac in solution and the immobilized coating antigen to react with the limited binding sites of the polyclonal antibody to form the immunocomplex. The second antibody labelled with horseradish peroxidase was introduced into the immunosensor and trapped by captured polyclonal antibody against diclofenac, which could effectively amplify chemiluminescence signals of luminol-PIP-H₂O₂. Under optimal conditions, the diclofenac could be detected quantitatively. The chemiluminescence intensity decreased linearly with the logarithm of the diclofenac concentration in the range of 0.1-100ngmL^-1 with a detection limit of 0.05ngmL^-1 at a signal-to-noise ratio of 3. The immunosensor exhibited high sensitivity, specificity and acceptable stability. This easy-operated and cost-effective analytical method could be valuable for the diclofenac determination in real water samples.

Simultaneous extraction and determination of trace amounts of diclofenac from whole blood using supported liquid membrane microextraction and fast Fourier transform voltammetry

A novel, simple, and inexpensive analytical technique based on flat sheet supported liquid membrane microextraction coupled with fast Fourier transform stripping cyclic voltammetry on a reduced graphene oxide carbon paste electrode was used for the extraction and online determination of diclofenac in whole blood. First, diclofenac was extracted from blood samples using a polytetrafluoroethylene membrane impregnated with 1-octanol and then into an acceptor solution, subsequently it was oxidized on a carbon paste electrode modified with reduced graphene oxide nanosheets. The optimal values of the key parameters influencing the method were as follows: scan rate, 6 V/s; stripping potential, 200 mV; stripping time, 5 s; pH of the sample solution, 5; pH of the acceptor solution,7; and extraction time, 240 min. The calibration curves were plotted for the whole blood samples and the method was found to have a good linearity within the range of 1-25 μg/mL with a determination coefficient of 0.99. The limits of detection and quantification were 0.1 and 1.0 μg/mL, respectively. Using this coupled method, the extraction and determination were merged into one step. Accordingly, the speed of detection for sensitive determination of diclofenac in complex samples, such as blood, increased considerably.