Molecular traits of phenolic moieties in dissolved organic matter: Linkages with membrane fouling development

New insight into soluble extracellular metabolites during sludge bulking process based on excitation-emission matrix spectroscopy and ultrahigh-performance liquid chromatography-mass spectrometry

Soluble extracellular metabolites (SEM) produced by microorganisms might significantly change during sludge bulking, which is a major operational problem caused by the excessive growth of filamentous bacteria. However, knowledge remains limited about the dynamics and potential role of SEM in the bulking of sludge. In this study, filamentous bulking was simulated in a laboratory-scale reactor and changes to SEM characteristics during the bulking process were investigated using excitation-emission matrix spectroscopy and ultrahigh-performance liquid chromatography-mass spectrometry. SEM components changed significantly at different phases of sludge bulking. Changes in SEM were closely correlated with the structure of the bacterial community. Based on the EEM profiles, significant increases in fulvic acid-like and humic acid-like substances in SEM were observed with the development of filamentous bulking. The degree of humification in SEM showed a clear increasing trend. Untargeted extracellular metabolomic analysis showed that the intensity of berberine and isorhamnetin in SEM increased significantly during the bulking phase, which might synergistically facilitate the development of filamentous bulking.

Combining Ultrafiltration and Nanofiltration to Obtain a Concentrated Extract of Purified Polyphenols from Wet Olive Pomace

Despite the environmental concerns raised every year by the generation of high volumes of wet olive pomace, it contains valuable phenolic compounds that are essential for the valorization of this by-product. In this work, an integrated process to recover phenolic compounds from wet olive pomace is proposed. It consists of ultrasound-assisted solid-liquid extraction, followed by ultrafiltration and nanofiltration. Several commercial membranes were studied at different operational conditions. The ultrafiltration stage allowed the purification of biophenols, which were obtained in the permeate stream. Regarding organic matter, satisfactory rejection values were obtained with both commercial UH030 and UP005 membranes (Microdyn Nadir), but the latter provided more efficient purification and higher values of permeate flux, above 18 L·h^-1·m^-2 at 2.5 bar and 1.5 m·s^-1. Later, this permeate stream was concentrated by means of a nanofiltration process, obtaining polyphenol rejection values that surpassed 85% with the commercial NF270 membrane (DuPont), then achieving the concentration of the previously purified polyphenols.

Unveiling the Impacts of Sodium Hypochlorite on the Characteristics and Fouling Behaviors of Different Commercial Polyvinylidene Fluoride Hollow Fiber Membranes

Sodium hypochlorite (NaOCl) is a commonly used cleaning agent for recovering membrane performance in membrane technologies. A thorough understanding of the impacts of NaOCl exposure on membrane properties and fouling behavior is important for optimizing chemical cleaning process and extending membrane lifespan. In this study, three commercial polyvinylidene fluoride (PVDF) hollow fiber ultrafiltration membranes (SMM-1010, MEMCOR^® CS II and ZeeWeed 500) were used to systematically explore the effects of NaOCl dose and solution pH (8 and 10) on membrane properties. The results showed that membrane pores increased with exposure time prolonging, and more pores were observed at pH 8 aging condition. The amide group in the Fourier transformation infrared spectra was disappeared, while the carboxylic acid and succinimide groups were formed at pH 10 and pH 8 conditions, respectively. The hydrophilicity and pure water permeability (PWP) of SMM-1010 and MEMCOR^® CS II membranes had insignificant changes during NaOCl aging process, whereas the hydrophilicity of ZeeWeed 500 membrane slightly decreased and its PWP increased by 1.4-fold. The antifouling properties of NaOCl-aged SMM-1010 and MEMCOR^® CS II membranes were slightly improved, whereas the NaOCl-aged ZeeWeed 500 membrane showed severer flux decline with humic acid filtration. Our findings could provide guidance for practical chemical cleaning process optimization.

Sustainable microalgal biomass valorization to bioenergy: Key challenges and future perspectives

The global trend is shifting toward circular economy systems. It is a sustainable environmental approach that sustains economic growth from the use of resources while minimizing environmental impacts. The multiple industrial use of microalgal biomass has received great attention due to its high content of essential nutrients and elements. Nevertheless, low biomass productivity, unbalanced carbon to nitrogen (C/N) ratio, resistant cellular constituents, and the high cost of microalgal harvesting represent the major obstacles for valorization of algal biomass. In recent years, microalgae biomass has been a candidate as a potential feedstock for different bioenergy generation processes with simultaneous treating wastewater and CO₂ capture. An overview of the appealing features and needed advancements is urgently essential for microalgae-derived bioenergy generation. The present review provides a timely outlook and evaluation of biomethane production from microalgal biomass and related challenges. Moreover, the biogas recovery potential from microalgal biomass through different pretreatments and synergistic anaerobic co-digestion (AcoD) with other biowastes are evaluated. In addition, the removal of micropollutants and heavy metals by microalgal cells via adsorption and bioaccumulation in their biomass is discussed. Herein, a comprehensive review is presented about a successive high-throughput for anaerobic digestion (AD) of the microalgal biomass in order to achieve for sustainable energy source. Lastly, the valorization of the digestate from AD of microalgae for agricultural reuse is highlighted.

Two-Dimensional Infrared Correlation Spectroscopy, Conductor-like Screening Model for Real Solvents, and Density Functional Theory Study on the Adsorption Mechanism of Polyvinylpolypyrrolidone for Effective Phenol Removal in an Aqueous Medium

The discharge of industrial effluents, such as phenol, into aquatic and soil environments is a global problem due to its serious negative impacts on human health and aquatic ecosystems. In this study, the ability of polyvinylpolypyrrolidone (PVPP) to remove phenol from an aqueous medium was investigated. The results showed that a significant proportion of phenol (up to 74.91%) was removed using PVPP at pH 6.5. Isotherm adsorption experiments of phenol on PVPP indicated that the best-fit adsorption was obtained using Langmuir models. The response peaks of the hydroxyl groups of phenol (OH) and the carboxyl groups (i.e., C=O) of PVPP were altered, indicating the formation of a hydrogen bond between the PVPP and phenol during phenol removal, as characterized using 1D and 2D IR spectroscopy. The resulting complexes were successfully characterized based on their thermodynamic properties, Mulliken charge, and electronic transition using the DFT approach. To clarify the types of interactions taking place in the complex systems, quantum theory of atoms in molecules (QTAIM) analysis, reduced density gradient noncovalent interaction (RDG-NCI) approach, and conductor-like screening model for real solvents (COSMO-RS) approach were also successfully calculated. The results showed that the interactions that occurred in the process of removing phenol by PVPP were through hydrogen bonding (based on RDG-NCI and COSMO-RS), which was identified as an intermediate type (∇2ρ(r) > 0 and H < 0, QTAIM). To gain a deeper understanding of how these interactions occurred, further characterization was performed based on adsorption mechanisms using molecular electrostatic potential, global reactivity, and local reactivity descriptors. The results showed that during hydrogen bond formation, PVPP acts as a nucleophile, whereas phenol acts as an electrophile and the O9 atom (i.e., donor electron) reacts with the H22 atom (i.e., acceptor electron).

Lower C/N ratio induces prior utilization of soluble microbial products with more dramatic variability and higher biodegradability in denitrification by strain YSF15

The emphasis of this study lies in how strain SYF15 regulates molecular weight (MW) fractions of soluble microbial products (SMPs) in response to low carbon to nitrogen (C/N) ratio, with high denitrification performance (over 99%). Results indicated SMPs with MW >100 and <50 kDa undoubtedly participated in denitrification before 12.0 h in C/N = 2.0, while sodium acetate was preferred in C/N = 5.0, indicating strain YSF15 was induced to degrade SMPs as a carbon source in low C/N. Additionally, lower C/N activated the extracellular metabolism, with increased fluorescence regional integration (FRI) volume amplitude by 48.08 and 53.43% (versus C/N = 5.0) in MW = 50-10 and 10-3 kDa, respectively. The FRI volume of proteins yielded greater with more degradable components than higher C/N in MW = 100-3 kDa, whereas polysaccharide and protein concentrations differed little with considerable biodegradability, implying components inside protein changed dramatically. This pioneering work contributed to the understanding of denitrification with carbon source deficiency.

Biochemical characteristics and membrane fouling behaviors of soluble microbial products during the lifecycle of Escherichia coli

The complexity of production process and chemical compositions of soluble microbial products (SMPs) largely limits the understanding of membrane fouling in membrane bioreactors (MBRs). Herein, we used a model single-strain Escherichia coli to better understand the chemical natures of SMPs and their roles in membrane fouling. The effects of carbon source and growth phase on the chemical compositions of SMPs were identified at both the compound and molecular levels by using advanced techniques including excitation emission matrix and parallel factor analysis (EEM-PARAFAC), size exclusion chromatography coupled with organic carbon detection (LC-OCD), and untargeted ultra-performance liquid chromatography - Q-Exactive - mass spectrometry (UPLC-Q-Exactive-MS). Subsequently, the roles of SMPs in the propensity of membrane fouling during ultrafiltration (UF) were studied. The results showed that the chemical compositions and fouling potentials of SMPs were carbon source- and growth phase-dependent. In the exponential phase, SMPs mainly consisted of utilization-associated products (UAPs) and remaining substrates. As the microorganism progressed into the stationary and senescent phases, UAPs and biomass-associated products (BAPs) were the main components, respectively. The SMP contents generated in glucose medium were higher than those generated in acetate medium, and higher abundances of humic fluorescent components were observed in glucose-fed SMPs. Van Krevelen diagrams of the UPLC-MS results revealed that acetate-fed SMPs contained more carboxylic-rich alicyclic molecules, peptides-like, aromatic, and carbohydrates-like components than glucose-fed SMPs in the stationary and senescent phases. These components played a significant role in irreversible membrane fouling, as evidenced in UF experiments. Standard blocking and cake filtration were the main fouling mechanisms for the filtration of SMPs collected in the exponential and stationary/senescent phases, respectively. Our findings highlight linkages between SMP compositions and membrane fouling at both the compound and molecular levels and suggest that both the carbon source and growth phase strongly determine the production potential, chemical nature, and fouling behavior of SMPs.

Molecular characterization of size-segregated organic aerosols in the urban boundary layer in wintertime Beijing by FT-ICR MS

Organic aerosols, complicated mixtures of organic compounds, are important constituents of atmospheric particulate matter. However, little is known about the size distributions and vertical profiles of these constituents at a molecular level in the urban boundary layer. Here, we characterized the molecular compositions of size-segregated samples collected simultaneously at two heights (8 m and 260 m above ground level) in urban Beijing during the winter of 2018. The CHO, CHNO, CHOS, and CHNOS subgroups in water-soluble organic carbon were characterized using a 15-T ultrahigh-resolution Fourier transform-ion cyclotron resonance (FT-ICR) mass spectrometer. We found that both their numbers and magnitudes increased with a decrease in the particle size, especially for high molecular weight (HMW) compounds, except CHNOS. The number of CHNOS species also increased in the coarse mode, presumably because the alkalinity could inhibit their hydrolysis in the coarse mode. The compounds in small particles with higher O/C ratios and carbon oxidation state were possibly more aged, while the coarse particles with more lipid- and peptide-like compounds should originate from fresh emissions. Moreover, as the oxidation state increases in small particles, functionalization is enhanced for sulfur-containing compounds with fracturing of the benzene ring, while CHO and CHNO are potentially dominated by demethylation with ring-retaining products. It is worth noting that common compounds with the same molecular characteristics accounted for more than 86% of the total compounds between 260 m and ground level (8 m), demonstrating that the aerosols were well mixed in the urban boundary layer. Nonetheless, the relative content of the compounds was higher at ground level due to the impact of primary emissions, which increased with the particle size. In addition, the compounds in submicron particles were more oxidized at 260 m, while the opposite was observed in the coarse mode.

Monitoring dissolved organic matter in wastewater and drinking water treatments using spectroscopic analysis and ultra-high resolution mass spectrometry

Dissolved organic matter (DOM) plays a critical role in determining the quality of wastewater and the safety of drinking water. This is the first review to compare two types of popular DOM monitoring techniques, including absorption spectroscopy and fluorescence excitation-emission matrices (EEMs) coupled with parallel factor analysis (PARAFAC) vs. Fourier transform ion cyclotron resonance mass spectrometry (FT-ICR-MS), for the applications in wastewater and drinking water treatments. The optical techniques provide a series of indices for tracking the quantity and quality of chromophoric and fluorescent DOM, while FT-ICR-MS is capable of identifying thousands of DOM compounds in wastewater and drinking water at the molecule level. Both types of monitoring techniques are increasingly used in studying DOM in wastewater and drinking water treatments. They provide valuable insights into the variability of DOM composition in wastewater and drinking water. The complexity and diversity of DOM highlight the challenges for effective water treatments. Different effects of various treatment processes on DOM are also assessed, which indicates that the information on DOM composition and its removal is key to optimize the treatment processes. Considering notable progress in advanced treatment processes and novel materials for removing DOM, it is important to continuously utilize these powerful monitoring tools for assessing the responses of different DOM constituents to a series of treatment processes, which can achieve an effective removal of DOM and the quality of treated water.

Development of a quantitative structure-activity relationship model for mechanistic interpretation and quantum yield prediction of singlet oxygen generation from dissolved organic matter

Singlet oxygen (¹O₂) is capable of degrading organic contaminants and inducing cell damage and inactivation of viruses. It is mainly generated through the interaction of dissolved oxygen with excited triplet states of dissolved organic matter (DOM) in natural waters. The present study aims at revealing the underlying mechanism of ¹O₂ generation and providing a potential tool for predicting the quantum yield of ¹O₂ (Φ_1O2) generation from DOM by constructing a quantitative structure-activity relationship (QSAR) model. The determined Φ_1O2 values for the selected DOM-analogs range from (0.54 ± 0.23) × 10^-2 to (62.03 ± 2.97) × 10^-2. A QSAR model was constructed and was proved to have satisfactory goodness-of-fit and robustness. The QSAR model was successfully used to predict the Φ_1O2 of Suwannee River fulvic acid. Mechanistic interpretation of the descriptors in the model showed that hydrophobicity, molecular complexity and the presence of carbonyl groups in DOM play crucial roles in the generation of ¹O₂ from DOM. The presence of other heteroatoms besides O, such as N and S, also affects the generation of ¹O₂. The results of this study provide valuable insights into the generation of ¹O₂ from DOM in sunlit natural waters.